Optimisation of Longitudinal Polishing of Miniature High-Cycle Fatigue Specimens Using Response Surface Methodology with Analysis of Covariance (RSM–ANCOVA)
Surface preparation represents a critical step in high-cycle fatigue (HCF) testing of miniature specimens, where even small variations in surface integrity may significantly affect crack initiation and increase experimental scatter. This study presents a statistical optimisation of the longitudinal polishing process for miniature 22CrMoNiWV8-8 (EN 1.6945) steel fatigue specimens using Response Surface Methodology combined with Analysis of Covariance (RSM-ANCOVA). A Design of Experiments consisting of 60 polishing trials was performed to investigate the effects of abrasive belt speed, feed rate, contact setting, and abrasive belt type, while the initial surface roughness was incorporated as a covariate. The analysis confirmed that the initial roughness significantly influenced the polishing response and therefore had to be considered during process optimisation. Among the investigated factors, abrasive belt type exhibited the strongest effect on the final surface quality. The medium abrasive belt achieved the highest adjusted mean roughness reduction (EMM = 0.282 µm) and the lowest variability of the final surface roughness and significantly outperformed the coarse belt (p < 0.001), while no statistically significant difference was observed between the medium and fine belts. Belt-specific RSM–ANCOVA models were used to describe differences in the response to polishing parameters. The proposed methodology supports the control of surface roughness in miniature specimens intended for HCF testing. Its effects on fatigue strength, fatigue life and fatigue-result variability require separate experimental verification.
Authors
- Jakub Fousek (ORCID: https://orcid.org/0009-0000-8587-2577)
- Ján Džugan (ORCID: https://orcid.org/0000-0001-8996-9341)
- Josef Sklenička (ORCID: https://orcid.org/0000-0002-2787-0466)
- Pavel Konopík (ORCID: https://orcid.org/0000-0002-1528-3205)
- Michal Povolný (ORCID: https://orcid.org/0000-0001-6814-7066)
- Jaroslava Fulemová (ORCID: https://orcid.org/0000-0002-7010-7968)
- Jan Hnátík (ORCID: https://orcid.org/0000-0003-2007-6291)
- Matouš Uhlík (ORCID: https://orcid.org/0000-0002-1304-0349)
- Jan Matoušek
- Karel Mrkvička (ORCID: https://orcid.org/0009-0000-5627-8122)
Institutions
- Comtes Fht (Czechia) (CZ)
- Czech Technical University in Prague (CZ)
- University of West Bohemia in Pilsen (CZ)
Publication Details
- Journal
- Materials
- Published
- 2026-11-16
- DOI
- https://doi.org/10.3390/ma19224855
- Primary Topic
- Advanced machining processes and optimization
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Ministerstvo Zdravotnictví Ceské Republiky