A Digitally Trimmable Bandgap Voltage Reference Using a Transmission-Gate Switched Resistor Ladder in 180-nm CMOS
Abstract A bandgap reference is only as good as the silicon it is built on, and silicon never repeats itself exactly. This paper follows one bandgap circuit from its variation-limited state before trim to a digitally corrected one after trim. The core is a folded-cascode-regulated, mirror-based reference in a 180-nm CMOS process with VDD = 1.8 V; the correction is a 3-bit transmission-gate-switched resistor ladder placed in the output branch. Before trim, a 200-point Monte Carlo run swept over all eight codes (− 50°C to 125°C) evaluates successfully at 199 points (99.5%) and has a mean reference of 1.235 V with σ = 80.15 mV (6.5%), a spread of 0.888–1.418 V and a temperature coefficient (TC) of 17.7–2570 ppm/°C, the upper extreme being a single outlier. After trim, a 20-point Monte Carlo run gives a mean of 1.193 V with σ = 51.69 mV (4.3%), a 35% reduction in σ, a spread of 1.112–1.297 V and a TC of 44.9–192.3 ppm/°C. At the nominal corner the reference falls from 1.206 V to 1.183 V over the range, about 105 ppm/°C. The trim step, switch-resistance effects and test-time code selection are analysed.
Authors
- Nutan Chaudhari
- Akhil Masurkar
- Rahul Bhadane
Institutions
- Vidyalankar Institute of Technology (IN)
Publication Details
- Journal
- Research Square
- Published
- 2026-11-16
- DOI
- https://doi.org/10.21203/rs.3.rs-11510006/v1
- Primary Topic
- Analog and Mixed-Signal Circuit Design
- Type
- preprint