Frost Accumulation on an Air-Source Heat Pump Coil Between Defrosts: Mass, Thickness and the Latent Load of One Heating Hour
Working from the same vapour-diffusion deposition operating on a finned coil in near-freezing humid air, where the surface sits below both zero and the frost point of the passing air, so frost accumulates between defrost cycles and the deposited latent heat is drawn from the refrigerant circuit, the paper prices one situation for the heat pump case: an outdoor heat pump coil with surface at minus eight degrees Celsius in air at two degrees and eighty-five percent relative humidity, vapour diffusing at 1.9e-5 m2 per second across an effective two-millimetre forced-flow layer, a starting frost density of eighty kg per cubic metre rising toward three hundred and a densification time of thirty minutes, frost conductivity at 0.12 W/m/K in conductivity units, and a one-hour interval between defrosts. Its stated products are the mass of frost accumulated per square metre of coil face in one hour, the layer thickness before and after densification, the latent heat released during deposition, and how the flux responds to moister air or a thicker boundary layer. For the heat pump case, vapour arrives at 75.0 g/m2/h, building for the heat pump case a layer 0.937 mm thick at deposition density and 0.075 kg/m2 in total; densification for the heat pump case trims the standing layer to 0.278 mm. A heat pump in a damp cold snap spends part of its life melting the frost it grew; this budget sizes the growth half of that bargain.
Authors
- William Alexander Aldred (ORCID: https://orcid.org/0009-0000-1215-577X)
Publication Details
- Journal
- Zenodo (CERN European Organization for Nuclear Research)
- Published
- 2026-11-15
- DOI
- https://doi.org/10.5281/zenodo.24242699
- Primary Topic
- Refrigeration and Air Conditioning Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00