Improvement of Working Capacity of Disks of Ploughshares of Grain Seeders by Welding a Repair Part
BACKGROUND: During operation, the disks of the ploughshares of grain seeders experience severe friction against the soil, which leads to their active abrasive wear, a decrease in the quality of sowing and yield of grain crops. In this regard, the failure of disks due to wear is decisive and requires frequent restoration of working condition. AIM: evaluation of efficiency of recovery of ploughshare disks by welding of repair part with further electromechanical hardening. MATERIALS AND METHODS: A method and a device are developed for welding a repair part in the form of ring fragments to ploughshare disks with wear along a diameter of 24 mm and more. Welding type, electrode selection, welding modes and repair part material are substantiated on the basis of multi-criteria approach on technical and economic assessment, manufacturability, criteria of modes and strength. A comparative assessment of experimental and serial disks for wear resistance was carried out by bench tests with modeling of operating conditions of disk ploughshares. Control of test parameters - change in the outer diameter, thickness, chamfer length, grinding angle and hardness of the disc material over the test period, equivalent to an average work volume of about 650 hectares. RESULTS: The effect of increasing the operability of the working zone of the disks by welding a repair part with subsequent electromechanical hardening is achieved. The multi-criteria approach when welding repair parts ensured uniform hardness in the zone of the seam and the main material of the restored disk. As a result, the wear resistance after restoration and hardening of worn discs compared to commercially available ones increases by 20.0... 25.0%. Analysis of the results showed a significant effect of welding a repair part with subsequent electromechanical hardening on increasing wear resistance for all evaluated parameters. CONCLUSION: Comparison of the wear of the ploughshare disks during bench tests with the data in operation showed that at an average operating time of 650 hectares, the increase in the durability of the restored hardened disks averages 22.5%, which is equivalent to processing 146 hectares. The technical and economic assessment of the introduction of welding of the repair part with the subsequent electromechanical strengthening of the ploughshare discs shows a decrease in specific operating costs per hectare when using repaired discs by an average of 25.0%.
Authors
- Sergey Volvak (ORCID: https://orcid.org/0000-0002-6955-7144)
- Тимашов Евгений Петрович (ORCID: https://orcid.org/0000-0003-0740-8714)
- Alexander Pastukhov (ORCID: https://orcid.org/0000-0001-8249-8970)
- Dmitriy Bakharev (ORCID: https://orcid.org/0009-0005-4263-740X)
- M. N. Erokhin (ORCID: https://orcid.org/0000-0001-6573-0950)
- Mikail Ivanovich Volkov (ORCID: https://orcid.org/0009-0009-0267-5224)
Institutions
- Russian State Agrarian University - Moscow Timiryazev Agricultural Academy (RU)
- Belgorod State Agricultural University (RU)
Publication Details
- Journal
- Tractors and Agricultural Machinery
- Published
- 2026-11-15
- DOI
- https://doi.org/10.17816/0321-4443-698246
- Primary Topic
- Metal Alloys Wear and Properties
- Type
- article
- Field-Weighted Citation Impact
- 0.00