Development of a Thermally Conjugate Bifilar Planar Coil Magnetic Exposure Platform for Cell Cultures and Pilot Comparison of Equal-RMS ELF Modulations in an L929 Fibroblast Wound Closure Model (Hücre Kültürleri İçin Isıl Olarak Eşlenik Bifilar Plana

This record is a bilingual (Turkish and English) research proposal and study protocol for a magnetic exposure platform for cell cultures. The coil design, driver and dosimetry have been calculated and tested numerically, and the code, PCB design files and simulation outputs are included. No clinical or therapeutic claim is made. Problem. Reported effects of extremely low-frequency (ELF) magnetic fields on cell cultures are inconsistent. One reason may be that an unpowered control coil does not reproduce the heating of the powered coil. Platform. The exposure coil is a low-profile, 4-layer planar PCB coil that sits under a standard culture plate. The coil is bifilar. In active mode, the two windings carry current in the same direction and produce a field. In sham mode, the currents run in opposite directions, so the fields cancel while the same heat is produced. A palindromic layer order (A,B → B,A → B,A → A,B) is used to cancel the stray field from the layer transitions. The bifilar principle itself is not new. The contribution is adapting it to an under-plate PCB coil and making thermal equivalence a measured acceptance criterion. Target values at the cell plane (z ≈ 2.5 mm, 12 mm diameter region): 0.10 mT RMS at 7.83 Hz (±5%); sham residual field below 3%; DC offset below 0.1 mA; active–sham temperature difference within 0.05 °C. The magnetic field, layer tolerances, induced electric field and heating were calculated numerically for this geometry. A 4-channel constant-current driver was designed and tested in nonlinear circuit simulation. The target values above will be confirmed by bench measurement before any cell work. Planned pilot study. L929 fibroblasts will be tested in a scratch (wound closure) assay under four conditions: sham (S0); continuous sine (S1); phase-decohered sine (S2); 1 min on / 3 min off burst sine (S3). All active conditions have the same RMS field. The design is a 4-station Latin square over 12 independent days (n = 12 per condition). The primary outcome is the normalised open wound area averaged over 0–36 h. The main comparisons are S2 vs S1 and S3 vs S1. S1 vs sham is a secondary comparison. Equivalence is tested with TOST (±10 percentage points). Image analysis will be blinded. The analysis plan will be time-stamped before the first cell experiment. Cell work will not start until all physical acceptance criteria have been measured and met. This pilot can detect only large effects. Files: Report: Turkish + English combined PDF/DOCX (main file), plus English-only and Turkish-only versions. Archive (ZIP): Python code for the 3D Biot–Savart field, tolerance analysis, induced electric field, transient thermal model, driver simulation and statistical power/TOST simulations; simulation outputs and figures; KiCad and Gerber files for the 4-layer coil; empty data-recording templates. SHA256SUMS.txt: checksums for every file. License: Code under MIT; text, figures and PCB design under CC BY 4.0. See LICENSE.txt. Version 1.0.0, 15 November 2026.

Authors

Institutions

Publication Details

Journal
Zenodo (CERN European Organization for Nuclear Research)
Published
2026-11-15
DOI
https://doi.org/10.5281/zenodo.24242387
Primary Topic
Electromagnetic Fields and Biological Effects
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Development of a Thermally Conjugate Bifilar Planar Coil Magnetic Exposure Platform for Cell Cultures and Pilot Comparison of Equal-RMS ELF Modulations in an L929 Fibroblast Wound Closure Model (Hücre Kültürleri İçin Isıl Olarak Eşlenik Bifilar Plana

Furkan GÜVEN
Zenodo (CERN European Organization for Nuclear Research)
Electromagnetic Fields and Biological Effects
article

Development of a Thermally Conjugate Bifilar Planar Coil Magnetic Exposure Platform for Cell Cultures and Pilot Comparison of Equal-RMS ELF Modulations in an L929 Fibroblast Wound Closure Model (Hücre Kültürleri İçin Isıl Olarak Eşlenik Bifilar Plana

Furkan GÜVEN
article en

Abstract

This record is a bilingual (Turkish and English) research proposal and study protocol for a magnetic exposure platform for cell cultures. The coil design, driver and dosimetry have been calculated and tested numerically, and the code, PCB design files and simulation outputs are included. No clinical or therapeutic claim is made. Problem. Reported effects of extremely low-frequency (ELF) magnetic fields on cell cultures are inconsistent. One reason may be that an unpowered control coil does not reproduce the heating of the powered coil. Platform. The exposure coil is a low-profile, 4-layer planar PCB coil that sits under a standard culture plate. The coil is bifilar. In active mode, the two windings carry current in the same direction and produce a field. In sham mode, the currents run in opposite directions, so the fields cancel while the same heat is produced. A palindromic layer order (A,B → B,A → B,A → A,B) is used to cancel the stray field from the layer transitions. The bifilar principle itself is not new. The contribution is adapting it to an under-plate PCB coil and making thermal equivalence a measured acceptance criterion. Target values at the cell plane (z ≈ 2.5 mm, 12 mm diameter region): 0.10 mT RMS at 7.83 Hz (±5%); sham residual field below 3%; DC offset below 0.1 mA; active–sham temperature difference within 0.05 °C. The magnetic field, layer tolerances, induced electric field and heating were calculated numerically for this geometry. A 4-channel constant-current driver was designed and tested in nonlinear circuit simulation. The target values above will be confirmed by bench measurement before any cell work. Planned pilot study. L929 fibroblasts will be tested in a scratch (wound closure) assay under four conditions: sham (S0); continuous sine (S1); phase-decohered sine (S2); 1 min on / 3 min off burst sine (S3). All active conditions have the same RMS field. The design is a 4-station Latin square over 12 independent days (n = 12 per condition). The primary outcome is the normalised open wound area averaged over 0–36 h. The main comparisons are S2 vs S1 and S3 vs S1. S1 vs sham is a secondary comparison. Equivalence is tested with TOST (±10 percentage points). Image analysis will be blinded. The analysis plan will be time-stamped before the first cell experiment. Cell work will not start until all physical acceptance criteria have been measured and met. This pilot can detect only large effects. Files: Report: Turkish + English combined PDF/DOCX (main file), plus English-only and Turkish-only versions. Archive (ZIP): Python code for the 3D Biot–Savart field, tolerance analysis, induced electric field, transient thermal model, driver simulation and statistical power/TOST simulations; simulation outputs and figures; KiCad and Gerber files for the 4-layer coil; empty data-recording templates. SHA256SUMS.txt: checksums for every file. License: Code under MIT; text, figures and PCB design under CC BY 4.0. See LICENSE.txt. Version 1.0.0, 15 November 2026.

Zenodo (CERN European Organization for Nuclear Research)
Fırat University (TR)
Electromagnetic Fields and Biological Effects
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon