An in Vitro Comparative Analysis of Marginal Integrity and Surface Roughness between Novel 3D Printed Ceramic and Milled Zirconia Crowns
Introduction: This study aims to compare the marginal integrity and surface roughness of 3D-printed ceramic in comparison to zirconia-milled crowns across different stages, including pre- and post-polishing. The study evaluates the marginal fit and surface roughness of each crown type to determine their suitability for long-term dental restorations. Methods: A first maxillary molar typodont tooth was duplicated in epoxy resin, and crowns were fabricated using 3D-printed ceramic and zirconia-milling techniques. Surface roughness (Ra) measurements were taken at post production, pre and post-polishing using a polishing paste. Marginal fit assessment was done using Stereomicroscope. Statistical analyses were conducted to compare the results between ceramic and zirconia crowns. Results: Printed ceramic crowns exhibited a higher initial surface roughness (Ra ~3.5 µm) compared to milled ceramic crowns (Ra ~1.2 µm). However, printed ceramic crowns achieved a smoother surface post-polishing (Ra ~0.2 µm) than milled zirconia crowns. Overall milled zirconia crowns had a better marginal fit as compared to 3D printed ceramic crowns. Conclusion: Zirconia crowns outperform ceramic crowns in terms of marginal fit and surface smoothness, making them a superior choice for long-term posterior restorations. However, 3D-printed ceramic crowns offer flexibility and ease of customization, making them suitable for temporary or anterior restorations. This study reinforces zirconia’s role as the preferred material for permanent, load-bearing restorations, while 3D-printed ceramic shows promise for less demanding applications and provisional restorations.
Authors
- Ram Kiran Mehtab Singh Sidhu
Publication Details
- Journal
- Journal of chemical health risks
- Published
- 2026-11-13
- Primary Topic
- Dental materials and restorations
- Type
- article
- Field-Weighted Citation Impact
- 0.00