INFLUENCE OF ZIRCONIUM ON MECHANICAL AND WEAR PROPERTIES OF MONEL400 BY DOUBLE-WIRE ARC ADDITIVE MANUFACTURING
Additive manufacturing (AM) using Multi Wire Arc Additive Manufacturing (MWAAM) enables the production of high-performance nickel-based alloys with tailored properties. This study examines how zirconium (Zr) affects the microstructure and mechanical behavior of Monel 400 alloy. Three compositions (Monel 400, Monel 400 + 0.5 wt.% Zr, and Monel 400 + 1 wt.% Zr) were deposited layer-by-layer via wire arc. scanning electron microscopy (SEM)and Optical microscopy (OM) analyzed grain morphology and phase distribution, while Vickers micro-hardness testing (HV0.2) assessed local mechanical variations in different wall regions. Tensile tests in vertical and horizontal orientations evaluated the overall mechanical response. Results show Zr addition significantly impacts microstructure and properties the 1 wt.% Zr alloy had the most refined grains, higher hardness reaching approximately of 160 HV0.2 at top,165 HV0.2, and 140-145 at bottom, and tensile value in the horizontal orientation (H), exhibits the highest UTS (310) and YS (440). The 0.5 wt.% Zr alloy showed partial grain refinement and localized hardness peaks reaching a maximum of ~180 HV0.2 at top,145-150 HV0.2 at middle and 137 HV0.2 at bottom, while Monel 400 had coarse grains and lower performance. These results show the enhance Monel400 in additive manufacturing, indicating controlled Zr addition can improve microstructure and tensile properties for durable components in demanding environments
Authors
- Haneen Hameed Hlail
- Basem Al-Zubaidy
- Zuheir Talib Khulief
Publication Details
- Journal
- Kufa Journal of Engineering
- Published
- 2026-11-14
- DOI
- https://doi.org/10.30572/2018/kje/170427
- Primary Topic
- Additive Manufacturing Materials and Processes
- Type
- article
- Field-Weighted Citation Impact
- 0.00