ENHANCED INVESTIGATION OF CREEP AND FLEXURAL BEHAVIOR OF FDM PRINTED PLA CONSIDERING INFILL RATIO AND PRINTING ORIENTATIONS
The creep and flexural behavior of polylactic acid (PLA) specimens made by fused deposition modeling (FDM) at print orientations of 0°, 45°, and 90° and infill densities of 50%, 60%, 70%, 80%, 90%, and 100% are examined in this work. Using a three-point bending technique, standardized tests were performed to assess flexural characteristics and time-dependent deformation under constant load. The findings showed that the flexural modulus and creep strain were considerably impacted by both infill density and print orientation. 100% infill and a 0° orientation produced the best mechanical performance, but lower infill densities and orientations perpendicular to the load direction led to increased creep and decreased bending strength. These findings highlight the importance of optimizing FDM parameters for structural and functional applications, including medical orthotics, automotive prototypes, and educational tools
Authors
- Husam Jawad Abdulsamad (ORCID: https://orcid.org/0000-0001-9999-5682)
- Abbas Ali Diwan (ORCID: https://orcid.org/0000-0002-6431-0417)
- Aseel Abbas Hameed
Publication Details
- Journal
- Kufa Journal of Engineering
- Published
- 2026-11-14
- DOI
- https://doi.org/10.30572/2018/kje/170407
- Primary Topic
- Additive Manufacturing and 3D Printing Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00