HIGH-EFFICIENCY TRIPLE-INPUT DC–DC CONVERTER WITH OPTIMIZED DESIGN FOR RENEWABLE POWER SYSTEMS
Small renewable sources such as photovoltaic strings, fuel cells and batteries rarely share a common voltage, and none of these sources comes close to the 120 V bus expected by many auxiliary loads. A triple-input high step-up direct current to direct current (DC–DC) converter is reported here for exactly that situation. The circuit uses one switched-capacitor branch and three inductor–switch cells fed from 12 V, 24 V and 18 V, and was sized for 120 V at 2 A into a 60 Ω load, roughly the rating of an electric vehicle auxiliary rail. Duty ratios of 0.90, 0.80 and 0.85 set the three gains at 10, 5 and about 6.7. Each inductor (0.27 mH, 0.48 mH and 0.3825 mH) was chosen for the same 0.4 A current ripple, and a 22 µF capacitor holds the output ripple under 1 V at 100 kHz. Losses were estimated term by term: conduction and switching in every metal–oxide–semiconductor field-effect transistor (MOSFET), forward drop and reverse recovery in the diodes, copper and core loss in the inductors, equivalent series resistance (ESR) loss in the capacitor, and gate-drive power. The simulated total loss was 3.5 W with V1 alone and 5.75 W with all three inputs, i.e. 98.56% and 97.66% efficiency at 240 W, and the change of output voltage between no load and full load was 1.67%. In the triple-input case, 3.4 W of the 5.75 W was lost in the MOSFETs and diodes, so the switching devices, and not the inductors or the capacitor, limit further improvement. The converter is aimed at renewable source integration, electric vehicle auxiliary supplies and small distributed generation units
Authors
- M. Lokanadham
- E. Parimalasundar
Publication Details
- Journal
- Kufa Journal of Engineering
- Published
- 2026-11-14
- DOI
- https://doi.org/10.30572/2018/kje/170417
- Primary Topic
- Advanced DC-DC Converters
- Type
- article
- Field-Weighted Citation Impact
- 0.00