MIXED CONVECTION HEAT TRANSFER IN VENTILATEDCAVITIES FILLED WITH CU/ WATER AND CUO/ WATERNANOFLUIDS
Laminar mixed convection was computed in a square cavity with two openings, one tenth of the side high, at the foot of the vertical walls. Cold fluid entered on the left, and the right wall above the outlet was held at a higher uniform temperature. The fluid was water or a single-phase Cu or CuO suspension at 2, 6, and 10% by volume, with Brinkman viscosity and Maxwell conductivity. Finite-volume solutions covered to 500 at , and to at . At , the average Nusselt number of the heated wall rose from 4.77 to 15.94 between and 500. At 10% by volume, Cu raised it by 9.8 to 13.6% and CuO by 3.7 to 5.2%. Between 68 and 73% of the wall heat flow entered through the lowest third of the heated wall. At , the average Nusselt number peaked at . It fell by 22 to 24% at , where warm fluid stratified in the upper half of the cavity. The particle gain was largest at , 13.3% for Cu, where the Cu suspension kept a recirculating upper cell that water had lost. Under the property models, both particles raise the effective conductivity almost equally, so the advantage of Cu follows mainly from its higher density. The coolant left at 4 to 14% of the inlet-to-wall temperature difference, and at the upper cell recirculated 5.4 times the wall heat. The heat transfer predictions have not been validated against a benchmark with the same heating
Authors
- Fares Khalfallah (ORCID: https://orcid.org/0000-0002-7623-5194)
- Razik Benderradji (ORCID: https://orcid.org/0000-0002-0868-9004)
- Hamza Gouidmi (ORCID: https://orcid.org/0009-0004-4668-7570)
Publication Details
- Journal
- Kufa Journal of Engineering
- Published
- 2026-11-14
- DOI
- https://doi.org/10.30572/2018/kje/170424
- Primary Topic
- Nanofluid Flow and Heat Transfer
- Type
- article
- Field-Weighted Citation Impact
- 0.00