Dynamic Response and Stability Analysis of Underground Mine Water Sump Under Blasting Vibration

Blasting in open-pit mines can disturb permanent underground structures. This study examines an underground water sump in medium–hard dolomite at Kunyang Phosphate Mine. A detailed three-dimensional model was built in ANSYS Workbench. The Drucker–Prager (D-P) yield criterion was used. Measured acceleration time histories were applied throughout the model in three directions. Six cases were identified by representative peak vibration velocities of 6.4–27.1 cm/s. Transient dynamic analyses examined stress, displacement, vibration velocity and local safety reserve. High stresses occurred at junctions of the roof and walls, bottom corners and sump–shaft connections. The peak equivalent stress increased almost linearly from 8.08 to 12.90 MPa. The maximum principal stress showed local tension and compression. Its tensile peak increased from 0.72 to 3.56 MPa. This was below the static tensile reference of 9.44 MPa for intact laboratory specimens. The minimum principal stress was mainly compressive. The peak compressive stress in the deep surrounding rock reached −15.10 MPa. Positive displacement peaks increased from 0.69 to 2.51 mm. Negative peaks changed from −0.80 to −2.71 mm. These values describe transient model responses. Positive velocity peaks increased from 6.36 to 26.74 cm/s. Cases P2–P6 exceeded the project control reference of 8.5 cm/s. The local indicator FS was greater than one for the extracted states at all nine monitoring locations. At high vibration levels, FS was about 1.25 at the arch baseline and the middle of the bottom side wall. These locations had relatively low reserves. The results provide a quantitative basis for blast parameter optimisation and vibration control for the water sump.

Authors

Institutions

Publication Details

Journal
Symmetry
Published
2026-11-13
DOI
https://doi.org/10.3390/sym18111900
Primary Topic
Geomechanics and Mining Engineering
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Dynamic Response and Stability Analysis of Underground Mine Water Sump Under Blasting Vibration

Jiantao Pang, Bo Sun, Shujian Li, Menglai Wang et al.
Symmetry
Geomechanics and Mining Engineering
article

Dynamic Response and Stability Analysis of Underground Mine Water Sump Under Blasting Vibration

Jiantao Pang, Bo Sun, Shujian Li, Menglai Wang, Changtao Wei, Yonghui Huang
article en

Abstract

Blasting in open-pit mines can disturb permanent underground structures. This study examines an underground water sump in medium–hard dolomite at Kunyang Phosphate Mine. A detailed three-dimensional model was built in ANSYS Workbench. The Drucker–Prager (D-P) yield criterion was used. Measured acceleration time histories were applied throughout the model in three directions. Six cases were identified by representative peak vibration velocities of 6.4–27.1 cm/s. Transient dynamic analyses examined stress, displacement, vibration velocity and local safety reserve. High stresses occurred at junctions of the roof and walls, bottom corners and sump–shaft connections. The peak equivalent stress increased almost linearly from 8.08 to 12.90 MPa. The maximum principal stress showed local tension and compression. Its tensile peak increased from 0.72 to 3.56 MPa. This was below the static tensile reference of 9.44 MPa for intact laboratory specimens. The minimum principal stress was mainly compressive. The peak compressive stress in the deep surrounding rock reached −15.10 MPa. Positive displacement peaks increased from 0.69 to 2.51 mm. Negative peaks changed from −0.80 to −2.71 mm. These values describe transient model responses. Positive velocity peaks increased from 6.36 to 26.74 cm/s. Cases P2–P6 exceeded the project control reference of 8.5 cm/s. The local indicator FS was greater than one for the extracted states at all nine monitoring locations. At high vibration levels, FS was about 1.25 at the arch baseline and the middle of the bottom side wall. These locations had relatively low reserves. The results provide a quantitative basis for blast parameter optimisation and vibration control for the water sump.

SymmetryVol. 18(11)
Kunming University of Science and Technology (CN)
Geomechanics and Mining Engineering
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon