Shape Targets for Lunar Regolith Preprocessing: A DEM Study of Roundness, Elongation and Angle of Repose
Rounding angular lunar regolith grains has been proposed to reduce abrasion on processing hardware (Shergill and Kingston, 2019), but its effect on flow has not been quantified as a design target. We used GPU discrete element simulations (Chrono DEM-Engine) of 2 mm multi-sphere grains to map the angle of repose in a quasi-2D slump test across four Wadell roundness levels (0.13 to 1.0) and three aspect ratios (0.6 to 1.0), with two seeds per shape. Contact parameters were calibrated so a reference angular grain gives 39.3 ± 0.4°, close to the 39.6° reported for the LHS-1 simulant. Across the grid the angle ranged from 39.4° (angular, elongated) to 30.6° (sphere). The four grid cases in the nominal roundness ≥ 0.8 and aspect ratio ≥ 0.8 corner settled at 30.6 to 33.5°, about 3 to 6° below crushed-like angular grains at aspect 0.8 (36.9°). Rounding did little for elongated grains: at aspect 0.6 the angle stayed between 36.2° and 39.4° at every roundness. A linear surface in roundness and aspect ratio gave a leave-one-out RMSE of 1.6°. Runs at lunar gravity for three shapes agreed with Earth gravity within 1.3°, with no gravity effect resolved. We propose nominal roundness ≥ 0.8 and aspect ratio ≥ 0.8 as a provisional shape target for regolith preprocessing, to be checked against laboratory tests. Shape templates, parameters, scripts and outputs are released openly.
Authors
- Luis Torres (ORCID: https://orcid.org/0000-0002-1252-7665)
Publication Details
- Published
- 2026-11-13
- DOI
- https://doi.org/10.22541/essoar.15012190/v1
- Primary Topic
- Granular flow and fluidized beds
- Type
- preprint