Simple One-Pot Strategy for Viscosity Reduction in Itaconic Acid-Based UPRs via End-Group Modification
Improving the processability of bio-based unsaturated polyester resins without compromising their performance remains a key challenge for their broader industrial adoption. This study investigates how post-polymerization modification reactions influence their molecular structure, intermolecular interactions and rheological behavior. A solvent-free, one-pot post-polymerization modification reaction using dimethyl itaconate was developed to modify the prepolymers directly after synthesis, without any additional purification steps. Acetylation served as a reference post-polymerization modification reaction. Four prepolymers with varying contents of hydroxyl groups in excess (10–40 mol.%) were prepared and then modified. Both approaches resulted in substantial reductions in viscosity up to 71% for end-capping with dimethyl itaconate and up to 61% for acetylation (relative to the corresponding non-modified prepolymers), markedly enhancing processability. However, mechanical properties were sensitive to the post-polymerization modification reactions: while acetylation led to a general decrease across all measured mechanical properties, end-capping resulted in retained or increased tensile modulus despite the reduction in tensile strength, highlighting the trade-off between flow behavior and structural integrity. This study demonstrates that targeted end-group modification can effectively tune resin processability, providing insight for the design of sustainable resin systems.
Authors
- Sanja I. Savić (ORCID: https://orcid.org/0000-0001-7021-9508)
- Katarina M. Antić (ORCID: https://orcid.org/0000-0001-7712-4974)
- Pavle M. Spasojevic (ORCID: https://orcid.org/0000-0001-8903-2102)
- M. Spasojević (ORCID: https://orcid.org/0000-0001-9134-6637)
- Vesna V. Panić (ORCID: https://orcid.org/0000-0003-3617-1533)
- Maja D. Marković (ORCID: https://orcid.org/0000-0002-8466-8539)
- Olga Pantić (ORCID: https://orcid.org/0000-0003-4667-2585)
Institutions
- University of Kragujevac (RS)
- University of Belgrade (RS)
- Institute of Chemistry, Technology and Metallurgy (RS)
Publication Details
- Journal
- Macromol—A Journal of Macromolecular Research
- Published
- 2026-11-13
- DOI
- https://doi.org/10.3390/macromol6040111
- Primary Topic
- Epoxy Resin Curing Processes
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Science Fund of the Republic of Serbia