Hierarchical Coordinated Path-Following Control of Four-Wheel Steer-by-Wire Vehicles with Corner Module Actuation

Four-wheel steer-by-wire vehicles enable independent steering actuation at each corner, providing greater control flexibility for coordinated vehicle motion and path following. However, finite actuator dynamics and local steering loads can affect the wheel angles actually delivered to the vehicle, thereby influencing the overall steering response. To address this issue, this paper proposes a three-layer hierarchical steering control strategy for coordinated vehicle motion and accurate corner-level execution in four-wheel steer-by-wire vehicles. First, model predictive control (MPC) generates coordinated front- and rear-axle steering commands using weights calibrated offline by particle swarm optimization (PSO) and bounded state-dependent corrections from a fuzzy neural network (FNN) to the preview curvature and yaw rate references. Second, instantaneous-center-of-rotation (ICR) geometry converts the axle commands into four-wheel reference angles, accounting for differences between the turning radii of the left and right wheels and maintaining geometric consistency. Finally, active disturbance rejection control (ADRC) improves the execution performance of four independent permanent-magnet synchronous motor (PMSM) steering modules driven by field-oriented control (FOC), enabling wheel reference tracking and compensation for local steering-load disturbances. Simulations under representative driving conditions show that the mean lateral root-mean-square (RMS) error under ideal steering execution is 0.0278 m, 55.4% lower than that of the two-wheel-steering baseline. Regarding the finite corner actuator dynamics and the associated execution controllers, the worst-case lateral RMS error is 0.0631 m, still 27.9% lower than the same baseline, while the peak vehicle sideslip angle remains below 2.30°, with the applicability of the proposed framework at higher speeds and the capability limitations of the steering execution system also analyzed and discussed. These results show that the proposed hierarchical control framework improves the lateral path-following performance of four-wheel steer-by-wire vehicles with corner module actuation and enhances steering control flexibility across different driving scenarios.

Authors

Institutions

Publication Details

Journal
Actuators
Published
2026-11-13
DOI
https://doi.org/10.3390/act15110601
Primary Topic
Vehicle Dynamics and Control Systems
Type
article
Field-Weighted Citation Impact
0.00

Funders

Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Hierarchical Coordinated Path-Following Control of Four-Wheel Steer-by-Wire Vehicles with Corner Module Actuation

Ju Xie, Jiaji Chen, Yuxuan Wang, Renjing Jin et al.
3 links
Actuators
Vehicle Dynamics and Control Systems
article

Hierarchical Coordinated Path-Following Control of Four-Wheel Steer-by-Wire Vehicles with Corner Module Actuation

Ju Xie, Jiaji Chen, Yuxuan Wang, Renjing Jin, Yugao Mao, Hexiang Huang
article en

Abstract

Four-wheel steer-by-wire vehicles enable independent steering actuation at each corner, providing greater control flexibility for coordinated vehicle motion and path following. However, finite actuator dynamics and local steering loads can affect the wheel angles actually delivered to the vehicle, thereby influencing the overall steering response. To address this issue, this paper proposes a three-layer hierarchical steering control strategy for coordinated vehicle motion and accurate corner-level execution in four-wheel steer-by-wire vehicles. First, model predictive control (MPC) generates coordinated front- and rear-axle steering commands using weights calibrated offline by particle swarm optimization (PSO) and bounded state-dependent corrections from a fuzzy neural network (FNN) to the preview curvature and yaw rate references. Second, instantaneous-center-of-rotation (ICR) geometry converts the axle commands into four-wheel reference angles, accounting for differences between the turning radii of the left and right wheels and maintaining geometric consistency. Finally, active disturbance rejection control (ADRC) improves the execution performance of four independent permanent-magnet synchronous motor (PMSM) steering modules driven by field-oriented control (FOC), enabling wheel reference tracking and compensation for local steering-load disturbances. Simulations under representative driving conditions show that the mean lateral root-mean-square (RMS) error under ideal steering execution is 0.0278 m, 55.4% lower than that of the two-wheel-steering baseline. Regarding the finite corner actuator dynamics and the associated execution controllers, the worst-case lateral RMS error is 0.0631 m, still 27.9% lower than the same baseline, while the peak vehicle sideslip angle remains below 2.30°, with the applicability of the proposed framework at higher speeds and the capability limitations of the steering execution system also analyzed and discussed. These results show that the proposed hierarchical control framework improves the lateral path-following performance of four-wheel steer-by-wire vehicles with corner module actuation and enhances steering control flexibility across different driving scenarios.

ActuatorsVol. 15(11)
Jiangsu University of Science and Technology (CN)
Joint Project of Industry-University-Research of Jiangsu Province
Vehicle Dynamics and Control Systems
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon