Multimaterial Hybrid Additive Manufacturing of Smart Polymer Structures with Embedded Electronics
Abstract Additive manufacturing (AM) provides a promising route for integrating electronic functionalities into polymer structures. However, existing approaches often rely on strong chemicals, post-processing, or assembly steps that limit design flexibility, manufacturing efficiency, and electrical reliability. This study presents a multimaterial hybrid AM strategy that integrates fused filament fabrication with cold spray additive manufacturing (CSAM) to fabricate polymer structures with embedded functionality. Tin (Sn) electrodes were directly deposited onto 3D-printed polymer substrates via CSAM and subsequently encapsulated through polymer over-printing, eliminating the need for surface pretreatment, thermal sintering, chemical metallization, or adhesive bonding. A systematic design of experiments with microstructural characterization established the process–structure–property relationships governing polymer metallization, identifying the optimal processing conditions for producing continuous conductive pathways with an electrical conductivity of 3.76 × 105 S·m–1. The versatility of the proposed approach was demonstrated through three representative fully embedded smart structures: (i) a strain sensor with a gauge factor of 2.766; (ii) a triboelectric nanogenerator (TENG) capable of generating a peak output voltage of ∼65 V and a peak power density of 3 μW cm–2; and (iii) a radio-frequency identification (RFID) circuit. These results provide a pathway toward smart polymer electronics (plastronics) for next-generation engineering systems.
Authors
- Semih Akin (ORCID: https://orcid.org/0000-0002-3644-7133)
- Grace Richard (ORCID: https://orcid.org/0000-0002-2805-3337)
- Sk Shamim Hasan Abir (ORCID: https://orcid.org/0000-0003-4079-1006)
- Joni C. Dhar
- Johnson Samuel (ORCID: https://orcid.org/0009-0000-9719-8161)
- Jaehun Jeon
- Shinan Huang
- Fotis Kopsaftopoulos
- Akshay R. Ananda
Institutions
- Rensselaer Polytechnic Institute (US)
Publication Details
- Journal
- ACS Applied Electronic Materials
- Published
- 2026-11-12
- DOI
- https://doi.org/10.1021/acsaelm.6c01769
- Primary Topic
- Nanomaterials and Printing Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Rensselaer Polytechnic Institute