Charge Regulation, Colloidal Stability and Adhesive Performance of Poly(vinyl alcohol)–Colloidal Silica Composites Modified with Guanidinium Polyacrylate Derived from Waste Guanidine Thiocyanate

Aims: To establish how a guanidinium polyacrylate (GPA) modifier obtained from waste guanidine thiocyanate controls the charge state, colloidal stability, rheology and service properties of poly(vinyl alcohol) (PVA)–colloidal silica composite adhesives. Study Design: Experimental study combined with colloid-chemical modelling (electrokinetics, ionic strength, DLVO and Stern–Langmuir analysis). Place and Duration of Study: Department of Chemical Technology, Bukhara State Technical University, Uzbekistan, from 5 March 2024 to 15 September 2026. Methodology: Composites were prepared with a basic formulation of 40 g GPA, 100 g of polymer matrix, 15 g of 30 % colloidal silica sol and 5 g of 37 % formalin; the GPA content was varied from 0 to 60 g and the sol content from 5 to 25 g. ζ-potential, hydrodynamic particle size, storage stability, rheological parameters, contact angles, work of adhesion, lap-shear adhesion strength, mechanical properties, water resistance and antibacterial activity were measured. Results: Increasing the GPA content shifted the ζ-potential from −28.6 to +16.8 mV, with charge reversal between 30 and 40 g and a maximum particle size (128.5 nm) at 30 g. Stoichiometric neutralisation of the silica surface charge would require only 0.01–0.07 g GPA, whereas the practical formulations (20–60 g) have an ionic strength of 0.17–0.50 mol/kg and a Debye length below 1 nm; the DLVO barrier vanishes above about 100 mM, so stability is provided mainly by adsorbed PVA and hydration forces. At 15 g of sol, the composite had η = 950 mPa·s, n = 0.68, particle size 89.6 nm and a storage life of 120 days. Adhesion strength was 6.8, 5.2, 6.1 and 6.4 MPa on metal, wood, glass and ceramics (44.4–61.9 % above the unmodified reference), water uptake after 24 h was 1.8 % (7.6 % for the reference), and the inhibition zone of 18.4 mm retained 91.8 % after washing. Conclusion: The GPA content and the silica-to-modifier ratio are the key variables that link the charge state of the dispersion with adhesion, water resistance and washing-resistant antibacterial activity; the basic formulation (40 g GPA and 15 g of 30 % sol per 100 g of matrix) provides the best compromise between these opposing requirements.

Authors

Institutions

Publication Details

Journal
Chemical Science International Journal
Published
2026-11-12
DOI
https://doi.org/10.9734/csji/2026/v35i61083
Primary Topic
Polymer Science and Applications
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Charge Regulation, Colloidal Stability and Adhesive Performance of Poly(vinyl alcohol)–Colloidal Silica Composites Modified with Guanidinium Polyacrylate Derived from Waste Guanidine Thiocyanate

Bobir Olimov, Qudratov Oston Hayrulla o`g`li
Chemical Science International Journal
Polymer Science and Applications
article

Charge Regulation, Colloidal Stability and Adhesive Performance of Poly(vinyl alcohol)–Colloidal Silica Composites Modified with Guanidinium Polyacrylate Derived from Waste Guanidine Thiocyanate

Bobir Olimov, Qudratov Oston Hayrulla o`g`li
article en

Abstract

Aims: To establish how a guanidinium polyacrylate (GPA) modifier obtained from waste guanidine thiocyanate controls the charge state, colloidal stability, rheology and service properties of poly(vinyl alcohol) (PVA)–colloidal silica composite adhesives. Study Design: Experimental study combined with colloid-chemical modelling (electrokinetics, ionic strength, DLVO and Stern–Langmuir analysis). Place and Duration of Study: Department of Chemical Technology, Bukhara State Technical University, Uzbekistan, from 5 March 2024 to 15 September 2026. Methodology: Composites were prepared with a basic formulation of 40 g GPA, 100 g of polymer matrix, 15 g of 30 % colloidal silica sol and 5 g of 37 % formalin; the GPA content was varied from 0 to 60 g and the sol content from 5 to 25 g. ζ-potential, hydrodynamic particle size, storage stability, rheological parameters, contact angles, work of adhesion, lap-shear adhesion strength, mechanical properties, water resistance and antibacterial activity were measured. Results: Increasing the GPA content shifted the ζ-potential from −28.6 to +16.8 mV, with charge reversal between 30 and 40 g and a maximum particle size (128.5 nm) at 30 g. Stoichiometric neutralisation of the silica surface charge would require only 0.01–0.07 g GPA, whereas the practical formulations (20–60 g) have an ionic strength of 0.17–0.50 mol/kg and a Debye length below 1 nm; the DLVO barrier vanishes above about 100 mM, so stability is provided mainly by adsorbed PVA and hydration forces. At 15 g of sol, the composite had η = 950 mPa·s, n = 0.68, particle size 89.6 nm and a storage life of 120 days. Adhesion strength was 6.8, 5.2, 6.1 and 6.4 MPa on metal, wood, glass and ceramics (44.4–61.9 % above the unmodified reference), water uptake after 24 h was 1.8 % (7.6 % for the reference), and the inhibition zone of 18.4 mm retained 91.8 % after washing. Conclusion: The GPA content and the silica-to-modifier ratio are the key variables that link the charge state of the dispersion with adhesion, water resistance and washing-resistant antibacterial activity; the basic formulation (40 g GPA and 15 g of 30 % sol per 100 g of matrix) provides the best compromise between these opposing requirements.

Chemical Science International JournalVol. 35(6)
Buxoro davlat texnika universiteti (UZ)
Polymer Science and Applications
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon