Integrated Design and Performance Evaluation of a Low-Voltage DC Distribution System Using Renewable Energy Sources

This paper presents the technical design and simulation-based performance evaluation of a low-voltage direct current (LVDC) distribution system for residential applications in Colombia. A hybrid architecture, in which a medium-voltage alternating current (MVAC) network supplies a centralised AC/DC converter feeding a 120 V DC residential network, is compared with a conventional AC distribution system. The design is evaluated in DIgSILENT PowerFactory through load-flow, harmonic, and short-circuit studies, the latter based on root-mean-square (RMS) simulations. At 500 m, and with the DC feeder operated hypothetically at the same voltage as the AC system (208 V), conductor losses were 0.506 kW in the DC section versus 1.608 kW in the AC system (about 69% lower); this reduction largely reflects the lower resistance of the selected DC feeder, which uses two conductors per pole, so it is specific to the feeder designs compared, and at the 120 V design voltage the DC losses are comparable to those of the AC system. As converter penetration increased, the voltage total harmonic distortion (THD) of the hybrid system remained between 4.0% and 4.3%, whereas in the AC system it rose from 1.63% to 8.77% with twelve photovoltaic (PV) inverters, with the final tuned filter and the default converter models of the simulation. Conversely, under dynamic loads the hybrid system required about 1.4 s after fault clearing to recover above 0.9 p.u., whereas the AC system recovered almost immediately. In the short-circuit study, the converter was modelled at ten times its 40 kVA design rating, which represents a conservative scenario for protection sizing; the simulated DC and AC fault-current magnitudes are therefore not directly comparable. In addition, the direct conversion from 208 V AC to 120 V DC assumed in the design would require a lower transformer secondary voltage or an additional DC/DC stage. These preliminary, simulation-based results should be confirmed with detailed electromagnetic transient models. Under the operating conditions and modelling assumptions considered, the hybrid architecture therefore offers better harmonic performance and, for the selected feeder designs, lower conductor losses, at the cost of more demanding protection and fault-recovery requirements.

Authors

Institutions

Publication Details

Journal
Electronics
Published
2026-11-12
DOI
https://doi.org/10.3390/electronics15225265
Primary Topic
HVDC Systems and Fault Protection
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Integrated Design and Performance Evaluation of a Low-Voltage DC Distribution System Using Renewable Energy Sources

Juan C. Vásquez, Eduardo Gómez-Luna, Juan Pablo Giraldo-Mosquera
Electronics
HVDC Systems and Fault Protection
article

Integrated Design and Performance Evaluation of a Low-Voltage DC Distribution System Using Renewable Energy Sources

Juan C. Vásquez, Eduardo Gómez-Luna, Juan Pablo Giraldo-Mosquera
article en

Abstract

This paper presents the technical design and simulation-based performance evaluation of a low-voltage direct current (LVDC) distribution system for residential applications in Colombia. A hybrid architecture, in which a medium-voltage alternating current (MVAC) network supplies a centralised AC/DC converter feeding a 120 V DC residential network, is compared with a conventional AC distribution system. The design is evaluated in DIgSILENT PowerFactory through load-flow, harmonic, and short-circuit studies, the latter based on root-mean-square (RMS) simulations. At 500 m, and with the DC feeder operated hypothetically at the same voltage as the AC system (208 V), conductor losses were 0.506 kW in the DC section versus 1.608 kW in the AC system (about 69% lower); this reduction largely reflects the lower resistance of the selected DC feeder, which uses two conductors per pole, so it is specific to the feeder designs compared, and at the 120 V design voltage the DC losses are comparable to those of the AC system. As converter penetration increased, the voltage total harmonic distortion (THD) of the hybrid system remained between 4.0% and 4.3%, whereas in the AC system it rose from 1.63% to 8.77% with twelve photovoltaic (PV) inverters, with the final tuned filter and the default converter models of the simulation. Conversely, under dynamic loads the hybrid system required about 1.4 s after fault clearing to recover above 0.9 p.u., whereas the AC system recovered almost immediately. In the short-circuit study, the converter was modelled at ten times its 40 kVA design rating, which represents a conservative scenario for protection sizing; the simulated DC and AC fault-current magnitudes are therefore not directly comparable. In addition, the direct conversion from 208 V AC to 120 V DC assumed in the design would require a lower transformer secondary voltage or an additional DC/DC stage. These preliminary, simulation-based results should be confirmed with detailed electromagnetic transient models. Under the operating conditions and modelling assumptions considered, the hybrid architecture therefore offers better harmonic performance and, for the selected feeder designs, lower conductor losses, at the cost of more demanding protection and fault-recovery requirements.

ElectronicsVol. 15(22)
Aalborg University (DK), Universidad del Valle (CO)
Industry, innovation and infrastructure, Affordable and clean energy
HVDC Systems and Fault Protection
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon