Experimental Evaluation and Reproducible Digital Filter Benchmarking for Hall-Sensor-Based DC Motor Speed Feedback

Hall-effect sensors are widely used for low-cost speed feedback in DC motor drives, yet the measured speed is influenced not only by controller design but also by hardware limitations and signal-processing characteristics. This study investigates the combined influence of these factors through an experimental evaluation of a Hall-sensor-based DC motor drive and an independent benchmark of commonly used digital low-pass filters. Open-loop measurements produced speed estimates of 201–202 rpm. With a 175 rpm reference, proportional control achieved only 124–127 rpm because the voltage available at the motor terminals was reduced by the combined effects of the power supply and the motor driver. Replacing the 6 V source with a 9 V laboratory supply increased the available motor voltage, allowing PI and PID controllers to achieve stable responses of 173–176 rpm and 173–177 rpm, respectively. Independently of the hardware experiments, fourth-order Bessel and Butterworth IIR filters and a 15th-order Hamming-window FIR filter were evaluated using a reproducible synthetic Hall-pulse benchmark at a 100 kHz sampling frequency. The FIR filter provided the lowest constant group delay (75 μs), whereas the IIR filters achieved approximately 57 dB attenuation at 10 kHz with higher frequency-dependent delays. The results show that observed speed-control performance can be strongly affected by hardware voltage constraints, while digital-filter selection requires balancing attenuation, delay, sampling frequency, and application requirements. Separating hardware evaluation from offline filter benchmarking provides a more reliable interpretation of Hall-sensor speed-feedback performance.

Authors

Institutions

Publication Details

Journal
Journal of Naval Sciences and Engineering
Published
2026-11-12
DOI
https://doi.org/10.56850/jnse.2007523
Primary Topic
Sensorless Control of Electric Motors
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
article

Experimental Evaluation and Reproducible Digital Filter Benchmarking for Hall-Sensor-Based DC Motor Speed Feedback

Atılgan Altinkök, Nuran Salimov
Journal of Naval Sciences and Engineering
Sensorless Control of Electric Motors
article

Experimental Evaluation and Reproducible Digital Filter Benchmarking for Hall-Sensor-Based DC Motor Speed Feedback

Atılgan Altinkök, Nuran Salimov
article en

Abstract

Hall-effect sensors are widely used for low-cost speed feedback in DC motor drives, yet the measured speed is influenced not only by controller design but also by hardware limitations and signal-processing characteristics. This study investigates the combined influence of these factors through an experimental evaluation of a Hall-sensor-based DC motor drive and an independent benchmark of commonly used digital low-pass filters. Open-loop measurements produced speed estimates of 201–202 rpm. With a 175 rpm reference, proportional control achieved only 124–127 rpm because the voltage available at the motor terminals was reduced by the combined effects of the power supply and the motor driver. Replacing the 6 V source with a 9 V laboratory supply increased the available motor voltage, allowing PI and PID controllers to achieve stable responses of 173–176 rpm and 173–177 rpm, respectively. Independently of the hardware experiments, fourth-order Bessel and Butterworth IIR filters and a 15th-order Hamming-window FIR filter were evaluated using a reproducible synthetic Hall-pulse benchmark at a 100 kHz sampling frequency. The FIR filter provided the lowest constant group delay (75 μs), whereas the IIR filters achieved approximately 57 dB attenuation at 10 kHz with higher frequency-dependent delays. The results show that observed speed-control performance can be strongly affected by hardware voltage constraints, while digital-filter selection requires balancing attenuation, delay, sampling frequency, and application requirements. Separating hardware evaluation from offline filter benchmarking provides a more reliable interpretation of Hall-sensor speed-feedback performance.

Journal of Naval Sciences and Engineering(Advanced Online Publication)
Naval Academy (TR), Milli Savunma Üniversitesi (TR), National Defence University (PK)
Sensorless Control of Electric Motors
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.

Laika access coming soon