Design and Optimization of 3D Printed ASA Substrate Based Antenna for Wi-Fi 6E
This paper presents design, optimization, and fabrication of a wideband microstrip patch antenna utilizing a 3D-printed acrylonitrile styrene acrylate (ASA) substrate for Wi-Fi 6E frequency band. The dielectric properties of the ASA substrate are determined using the ring resonator method. The bandwidth enhancement is achieved by modifying the conventional rectangular patch into a staircase-shaped structure and employing a partial ground plane. To fine-tune the antenna’s resonant frequency and bandwidth, a combination of curve fitting and particle swarm optimization (PSO) algorithm is utilized. The antenna comprises a patch with dimensions of 16.86 mm × 12.5 mm, situated on square substrate of size 27.5 mm × 27.5 mm. The antenna demonstrates a -10 dB impedance bandwidth ranging from 5.98 GHz to 8.62 GHz and a peak gain of 3.6 dBi at 6.525 GHz. Simulation and experimental results show good agreement, highlighting the potential of ASA as a viable substrate material for Wi-Fi 6E band antenna applications.
Authors
- Balwinder Singh Dhaliwal (ORCID: https://orcid.org/0000-0001-5092-017X)
- Garima Saini (ORCID: https://orcid.org/0000-0001-6525-5192)
- Manish Bijaraniya (ORCID: https://orcid.org/0009-0005-8180-7539)
- Kamal Gurgar (ORCID: https://orcid.org/0009-0005-0058-0492)
- Manju (ORCID: https://orcid.org/0009-0009-5393-3609)
Institutions
- National Institute of Technical Teachers Training and Research, Chandigarh (IN)
Publication Details
- Journal
- Electronics ETF
- Published
- 2026-11-12
- DOI
- https://doi.org/10.53314/els2630094m
- Primary Topic
- Antenna Design and Analysis
- Type
- article
- Field-Weighted Citation Impact
- 0.00