Microstructure engineering of sol–gel SiO 2 coatings with biomass derived carbon dots for enhanced corrosion protection of stainless steel
-0.003PP-CDs coating exhibited the most continuous microstructure, maintaining its integrity after immersion in 1.0 M HCl, whereas the undoped coating underwent severe cracking and delamination. Electrochemical measurements (EFM, PDP, and EIS) gave the same ranking, with inhibition efficiencies of 84-86% (EFM and PDP) for the 0.003 mg coating compared with 50-53% for undoped silica. EDS, contact angle, and AFM results were consistent with better retention of the 0.003 mg coating after immersion. The improvement over the undoped coating is primarily attributed to the addition of PP-CDs, which is accompanied by a change in film morphology and microstructure, from a cracked, agglomerated film to a continuous, more homogeneous one at 0.003 mg. These findings indicate that biomass-derived carbon dots can improve the short-term corrosion resistance of sol-gel silica coatings on stainless steel in hydrochloric acid under laboratory conditions.
Authors
- R. Helmy (ORCID: https://orcid.org/0000-0002-5355-0976)
- Nashwa S. Abdelshafi (ORCID: https://orcid.org/0000-0001-5170-1745)
- Hanan Atef Soliman (ORCID: https://orcid.org/0000-0002-8612-6039)
- Amr Gangan (ORCID: https://orcid.org/0000-0003-1650-5356)
- M. Saif
- H. A. Siam
Institutions
- Ain Shams University (EG)
- Al-Azhar University (EG)
Publication Details
- Journal
- RSC Advances
- Published
- 2026-11-18
- DOI
- https://doi.org/10.1039/d6ra08713b
- Primary Topic
- Corrosion Behavior and Inhibition
- Type
- article
- Field-Weighted Citation Impact
- 0.00