Fabrication and characterization of heavily doped p -type silicon layers via B 2 O 3 thermal diffusion and chemical mechanical polishing
Heavily boron-doped p -type Si layers were fabricated by thermal diffusion using B 2 O 3 . The effects of precursor concentration and annealing temperature on their electrical, morphological, and structural properties were investigated. The hole carrier concentration estimated from the sheet resistance increased systematically with increasing B 2 O 3 concentration and annealing temperature, reaching 5.85 × 10 19 cm −3 at 850 °C with 1.4% B 2 O 3 . The surface roughness of this sample was 0.143 nm and was further reduced to atomically smooth 0.076 nm by chemical mechanical polishing. X-ray diffraction and reciprocal-space mapping confirmed the preservation of high crystalline quality, while asymmetric rocking curves suggested depth-dependent strain associated with boron incorporation. Micro-Raman mapping revealed spatial variations in the local lattice state, which became more uniform after polishing. These results demonstrate a process for producing heavily doped p -type Si with high crystalline quality and an ultra-flat surface for low-resistance interfaces in Si-based spintronic devices.
Authors
- Fumiya Yamagishi
- M. Ishikawa (ORCID: https://orcid.org/0000-0001-5403-1767)
- Yuki Ishitsuka
- Nobuki Tezuka (ORCID: https://orcid.org/0000-0001-6497-7716)
- Ryota Otsuka
- Fumiya Kishi
- Daiju Harada
Institutions
- Nihon University (JP)
- Tohoku University (JP)
Publication Details
- Journal
- Japanese Journal of Applied Physics
- Published
- 2026-11-19
- DOI
- https://doi.org/10.35848/1347-4065/aeb696
- Primary Topic
- Semiconductor materials and devices
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Ministry of Education, Culture, Sports, Science and Technology
- Cabinet Office, Government of Japan
- Japan Society for the Promotion of Science