Design and Powertrain Sizing of an Electric Traction System Based on Commercially Available Components for Small-Scale Rural Vehicles
The electrification of small-scale rural vehicles offers a potential alternative to conventional fuel-powered vehicles for agricultural applications. This study presents the sizing of the motor and the transmission of an electric traction system for a small-scale rural utility vehicle intended for family farming. Commercially available components were prioritized to limit costs, although no quantitative economic assessment was performed. A 15-CV, 1800-rpm motor was evaluated analytically for speeds of up to 40 km/h and slopes of up to 50% at full load. The power required to start the fully loaded vehicle ranges from 2.42 CV (level terrain) to 13.03 CV (50% slope), and a two-range transmission with overall ratios of 5.1–55.4 is required. A longitudinal dynamics simulation, used as a consistency check, reproduced these values; with rolling resistance, aerodynamic drag, and drivetrain losses, continuous climbing of the 50% slope required 12.86–14.48 CV. With a 20% design margin derived from a sensitivity analysis, the motor torque suffices for continuous full-load climbing of slopes up to 40% on soil. For a 4 × 2 drive, adhesion, not motor power, limits full-load climbing on soil to about 20–33%; of the 7.5–20-CV ratings evaluated, 15 CV is the smallest that does not reduce this limit further. All results are theoretical and must be confirmed by prototype tests.
Authors
- Thais Castro (ORCID: https://orcid.org/0000-0002-0318-0233)
- Carlos Santos
- Teófilo Souza
Publication Details
- Journal
- World Electric Vehicle Journal
- Published
- 2026-11-17
- DOI
- https://doi.org/10.3390/wevj17110602
- Primary Topic
- Electric and Hybrid Vehicle Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00