Design, Simulation, and Experimental Validation of a Soft Robotic Finger with Variable Stiffness and Embedded Sensing
This work presents a soft finger that combines pneumatic actuation, variable stiffness, and embedded sensing and was designed, simulated, and experimentally tested. The finger integrates a fiber-reinforced pneumatic actuator with three interconnected chambers, located at the metacarpophalangeal (MCP), proximal interphalangeal (PIP), and distal interphalangeal (DIP) joints, which generate single-input underactuated bending. The prototype was fabricated by silicone casting in 3D-printed molds and incorporates a bio-based granular filler that allows post-deformation stiffening. Bending under pressurization was simulated with the Finite Element Method (FEM) in ANSYS using hyperelastic and fiber-composite material models. The simulation reproduces the trend of the experimental bending curve, with a mean absolute difference of approximately 8.7° over the tested pressure range. Vacuum-induced granular jamming increased the stiffness (slope of the force–displacement curve) by up to 35% and the mean applied force by up to 60% relative to the unstiffened state. A microphone embedded in the fingertip recorded distinct vibration signatures on three 3D-printed textured surfaces, indicating its potential for texture sensing; texture discrimination was not quantitatively validated. These results show that finger deformation and stiffness can be controlled with minimal hardware and a simple design, supporting its use as a component in soft grippers or robotic hands.
Authors
- Panagiotis Ν. Koustoumpardis (ORCID: https://orcid.org/0000-0002-3051-7321)
- Ioanna Tzoumani (ORCID: https://orcid.org/0009-0008-7106-9650)
- George Nikolakopoulos
- Konstantinos Karagiannis
Publication Details
- Journal
- Actuators
- Published
- 2026-11-19
- DOI
- https://doi.org/10.3390/act15110614
- Primary Topic
- Soft Robotics and Applications
- Type
- article
- Field-Weighted Citation Impact
- 0.00