Architecture-Dependent Reinforcement of FFF-Printed PLA Nanocomposites by Functionalized Multi-Walled Carbon Nanotubes

This study investigates the combined influence of multi-walled carbon nanotube (MWCNT) concentration and structural architecture on the compressive behavior of fused filament fabrication (FFF)-printed PLA components. Neat PLA and PLA reinforced with 1.0 and 2.0 wt% carboxyl-functionalized MWCNTs were characterized by Raman spectroscopy, DSC, TGA, compression testing, statistical analysis, and scanning electron microscopy. Thermal characterization showed that MWCNT incorporation caused only minor changes in PLA thermal degradation while altering its crystallization behavior. For nearly solid specimens (90% infill), compressive strength increased from 53.4 MPa for neat PLA to 73.6 MPa at 2.0 wt% MWCNTs, although differences among MWCNT concentrations were not statistically significant. Honeycomb structures exhibited the highest mechanical performance at 1.0 wt% MWCNTs, reaching a compressive strength of 33.3 MPa, approximately 59% higher than that of neat PLA, with significant improvements in both compressive strength and elastic modulus. Two-way ANOVA revealed significant interactions between structural architecture and MWCNT concentration for both compressive strength and elastic modulus, demonstrating an architecture-dependent reinforcement response. SEM provided complementary morphological evidence consistent with the observed mechanical trends. These findings demonstrate that the most effective MWCNT concentration depends on structural architecture, highlighting the importance of simultaneously optimizing material composition and geometry in FFF-manufactured polymer nanocomposites.