Experimental Investigation of the Impact of Cable Length and Type on Motor Overvoltages, Shaft Voltage, and Bearing Currents in PWM-Inverter-Fed Drive Systems

Fast-switching transients and high dv/dt associated with PWM inverters exacerbate the reflected-wave effects in the motor feeder cable. This leads to higher motor-side overvoltages, which increase the stress on the motor winding insulation, potentially accelerating insulation degradation and increasing the risk of partial discharge within the motor windings. Moreover, the common-mode voltages at the motor terminals propagate through parasitic capacitive paths within the motor, inducing shaft voltages that lead to electric discharge machining (EDM) currents and premature bearing failure. This paper experimentally investigates the influence of motor feeder cable length and type (shielded and unshielded) on motor terminal overvoltage, shaft voltage, and bearing current behavior in an inverter-fed 11 kW permanent magnet synchronous motor drive system. Three cable lengths (1 m, 3 m, and 16 m) with shielded and unshielded configurations are evaluated under identical operating conditions. Measurements of line-to-line voltage, line-to-ground voltage, shaft voltage, bearing current, and EDM discharge currents are recorded and statistically analyzed to assess the influence of cable configuration. The study also examines the influence of the motor grounding configuration on common-mode current and bearing current behavior. Overall, the findings provide comprehensive insights into the influence of motor feeder cable on overvoltage, shaft voltage, and bearing discharge behavior, supporting informed cable selection for WBG inverter-fed electric drives.