Surface Hydraulic Fracturing with L-Shaped Wells for Rock Burst Prevention in Hard Roof Key Strata of Deep Coal Mines

Targeting the rock burst hazard induced by the hard roof key stratum during deep mining at the Mengcun Coal Mine in the Binchang mining area, this study takes the No. 403109 working face as the engineering background and systematically investigates the rockburst prevention mechanism and effectiveness of ground hydraulic fracturing through theoretical analysis, UDEC numerical simulation, and surface microseismic monitoring. The results indicate that fracturing pre-weakens the overlying key stratum, transforming its load-bearing mode from a long-beam rigid support to a segmented flexible support. This significantly reduces the cantilever length, lowers the accumulation of elastic strain energy, and enables flexible load transfer and stress redistribution in the overburden. Numerical simulations reveal that after fracturing, the breakage timing of the key stratum advances, the fragmentation size decreases, and the over-burden movement shifts from stepwise fracturing to sequential caving, with the stress concentration zone substantially narrowed. In the field, a total of 44 fracturing stages were implemented in wells MC-05L and MC-06L, creating a fracture network with an average fracture length of 317 m and an average fracture height of 55 m, achieving an effective stimulated volume ratio of 86.7%. During the mining period, microseismic events exhibited a median energy of only 868.14 J, characterized by high frequency and low energy. The average weighting interval was 13.69 m, the peak coal stress was controlled within 5.0–6.7 MPa, and the loads on roadway bolts and cables remained within safe limits. This study validates the source-control effect of ground hydraulic fracturing on working faces with strong rock burst risks in deep mining, providing a theoretical basis and engineering reference for mines with analogous conditions.