Microstructure and Properties of Cu-Ni-W-Si Gradient Coating on Copper Alloy by Laser Cladding

To enhance the surface hardness and wear resistance of copper alloy workpieces, a Cu-Ni-W-Si gradient coating was fabricated on a Cu-Cr-Zr alloy substrate using coaxial powder-feeding laser cladding technology. Employing surface macroscopic morphology, flaw detection results, and cross-sectional microstructure as evaluation methods, along with the coating’s surface microhardness as a performance indicator, orthogonal experiments were sequentially conducted on the laser cladding process parameters for the Cu-Ni-10(W,Si) bottom layer and the Cu-Ni-20(W,Si) top layer. The optimized process parameters were identified as follows: a laser power of 4500 W (5000 W for the top layer), a scanning speed of 30 mm/s (60 mm/s for the top layer), and a scanning step of 2 mm. Subsequently, the phase composition and microstructure of the Cu-Ni-W-Si gradient coating were analyzed, and the microhardness distribution as well as the room-temperature friction and wear performance were evaluated. The results show that the coating achieves a hardness of 417 HV, which is 5.8 times higher than that of the substrate, and exhibits a wear rate of 3.52 × 10−4 mm3/Nm, corresponding to 49.1% of the substrate’s wear rate. The excellent performance of the coating is attributed to the favorable gradient metallurgical bonding between the coating and the substrate, as well as the presence of finely dispersed WSi2 high-hardness wear-resistant phases within the coating.