Energy Evolution and Deformation Analysis of Overloaded Limestone Under Complex Stress Conditions

Rock pillars in deep underground mines are subjected to complex stress environments. The combined effects of in situ stress and cyclic disturbances from mining activities lead to a redistribution of the surrounding rock mass stress field, which readily triggers instability and failure, posing severe threats to mining engineering safety. To investigate the damage mechanism of cyclic loading on rock and its weakening effect on the bearing capacity of mine pillars, this study takes limestone as the research object. A series of uniaxial compression tests were conducted on limestone specimens subjected to triaxial cyclic pre-damage, complemented by numerical simulations to further characterize the energy and deformation evolution of the damaged limestone under cyclic loading conditions. The findings are as follows: (i) Triaxial cyclic tests on limestone show that both the input energy and dissipated energy follow similar trends, decreasing rapidly in the initial stage before stabilizing. The elastic strain energy remains largely constant, with most of the input energy being stored as elastic strain energy. Under constant stress levels and cycle numbers, increases in confining pressure and frequency reduce the rock’s input energy, elastic strain energy, and dissipated energy. (ii) The peak stress of damaged limestone exhibits a positive correlation with the pre-damage confining pressure and cyclic frequency, while it decreases with an increasing number of cycles. Higher confining pressure and frequency raise the input energy, elastic potential energy, and dissipated energy at the peak stress point. (iii) Deformation and failure in damaged limestone originate from the development and propagation of localized deformation zones. Increased lateral displacement within these zones promotes the formation of macroscopic fractures. Due to significant structural heterogeneity inside the localized areas, the evolution of deformation energy is influenced by regional characteristics. (iv) Simulation results indicate that the uniaxial compressive failure of limestone involves the accumulation and propagation of micro-scale tensile cracks, which ultimately coalesce into macro-scale shear fracture surfaces. During uniaxial loading of pre-damaged limestone, newly generated cracks predominantly initiate around pre-existing cracks, with only a limited number distributed randomly. Their peak intensity shows a positive correlation with the pre-damage confining pressure.