Surface Evolution of an FDM-Printed PLA Component with Multiple Geometries During Centrifugal Disc Finishing

Additive manufacturing (AM) enables the fabrication of complex, customisable components from metals, composites and polymers such as polylactic acid (PLA); however, the process commonly produces poor surface finishes and inherent defects. Centrifugal disc finishing (CDF) is an established mass finishing technique in conventional manufacturing but remains insufficiently characterised for additively manufactured polymers. This exploratory study investigates the influence of CDF on fused deposition modelling (FDM)-fabricated PLA components with varying geometrical features, focusing on three-dimensional surface parameters including average areal surface roughness, skewness and kurtosis. Samples were processed up to 720 min with analysis at predetermined intervals to capture transient and steady-state-like behaviour. Surface characterisation was conducted using non-contact optical interferometry to obtain quantitative roughness data and three-dimensional topographical maps, supported by digital optical microscopy and gravimetric analysis to quantify material removal rates. Analysis of the experimental data indicated apparent relationships between processing time, geometry and surface response. Results indicate that material removal behaviour and roughness evolution may be geometry-dependent. Flat and convex surfaces appeared to follow expected transient-like and steady-state-like behaviour, whereas restricted geometries and intricate features exhibited distinct responses with characteristic transition times. Surface roughness reductions ranged from 36% to 89% depending on geometry. These findings provide preliminary quantitative insight into geometry-specific mass finishing behaviour, supporting improved process understanding and informing future optimisation of post-processing strategies for additively manufactured polymer components.