Construction and demolition waste-reinforced photopolymer resin for stereolithography (SLA) 3D printing
Additive manufacturing by stereolithography (SLA) enables the fabrication of components with high geometric complexity and dimensional precision. However, commercial photopolymer resins commonly exhibit limitations related to dimensional instability, shrinkage, warpage, and limited mechanical performance, restricting their application in areas requiring greater structural reliability. In this study, the effect of incorporating chamotte, a refractory ceramic waste derived from red ceramic production, into ultraviolet-curable photopolymer resin formulations processed by SLA was investigated. Different chamotte concentrations (0%, 0.5%, 1%, 1.5%, and 2 wt%) were evaluated to determine their influence on the physical, mechanical, and dimensional behavior of the printed structures. The residue was characterized by X-ray diffraction (XRD) and laser particle size analysis. The fabricated composites were characterized through tensile, compressive, flexural, Shore hardness, density, wettability, dimensional deviation, warpage, and directional shrinkage analyses, in addition to scanning electron microscopy. The results demonstrated that chamotte incorporation influenced both the mechanical and dimensional behavior of the SLA resin. The formulation containing 1.0 wt% chamotte presented the best overall performance, exhibiting reduced dimensional deviation, lower warpage, reduced anisotropic shrinkage, and improved dimensional accuracy compared to the neat resin. Improvements were also observed in tensile and flexural behavior, which correspond to the weakest mechanical responses of the unreinforced matrix. The findings indicate that low chamotte concentrations can act as sustainable dimensional stabilizers and ceramic reinforcements for SLA photopolymer systems, contributing to the development of more geometrically stable materials for additive manufacturing applications.
Authors
- Victor Paes Dias Gonçalves (ORCID: https://orcid.org/0000-0001-6469-5735)
- David Coverdale Rangel Velasco (ORCID: https://orcid.org/0000-0001-9800-9764)
- Felipe Perissé Duarte Lopes (ORCID: https://orcid.org/0000-0003-1867-6722)
- Noan Tonini Simonassi (ORCID: https://orcid.org/0000-0002-3571-5001)
- Ellen Bernardes de Lima
- Carlos Mauricio Fontes Vieira
Publication Details
- Journal
- Journal of Materials Science Materials in Engineering
- Published
- 2026-11-19
- DOI
- https://doi.org/10.1186/s40712-026-00636-1
- Primary Topic
- Additive Manufacturing and 3D Printing Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.00