Improving theThermal and Tribological Properties of Dimethyl Silicone Oil Using Ag/CNTs Composite as Multifunctional Additive

In this study, carboxyl groups were introduced onto CNT surfaces via acid oxidation, and Ag nanoparticles were successfully deposited onto the CNTs through an in situ chemical reduction method. At an Ag-to-CNTs100 mass ratio of 3:1, the as-prepared composite achieved a thermal conductivity of 1.45 W/(m·K) in dimethyl silicone oil, representing enhancements of 187.5% and 76.9% relative to pure Ag nanoparticles and pristine CNTs100, respectively, at equivalent loadings. Concurrently, tribological tests revealed that the AgHTs-3 at a 3:1 mass ratio and 25 wt% loading exhibited a steady-state friction coefficient of 0.08–0.12, reflecting an approximately 72% reduction compared with pure dimethyl silicone oil. Electrical conductivity measurements demonstrated that CO-CNTs100 attained saturation at 30 wt% with a resistivity of 36.5 Ω·m, whereas the AgHTs-3 nanocomposite achieved a resistivity of 4.7 Ω·m at 35 wt%. The incorporation of Ag nanoparticles effectively enhanced the overall performance of the nanocomposites. Through the formation of a synergistic heterostructure with carboxyl-functionalized carbon nanotubes, the composite not only significantly improved the thermal conductivity of dimethyl silicone oil but also effectively optimized the interfacial lubricating film while substantially reducing the friction coefficient and wear volume. Moreover, the introduction of silver promoted the dispersion stability of the composites in dimethyl silicone oil, enabling higher filler loadings and thereby effectively boosting electrical conductivity.