The Bending Impact of the Failure Investigation of the Polymer-Reinforced Composite Protection Bars

It is well established that an anti-intrusion beam is a passive safety system that serves an essential role for passengers during collisions. In this study, the influence of internal reinforcements on the bending failure of a cylindrical aluminum tube was systematically investigated through a series of composite beam tests. Polymeric materials, including cast polyamide (PA6) and polypropylene (PP), with varying wall thicknesses, were deemed suitable for use as the inner reinforcement of the Al 6063-T6 tube. The test setup, which simulates impact conditions experienced by structural components in full-scale crash tests, is a powerful tool for the bending impacts in the study. To describe the connection between bending impact and quasi-static loading of composite beams, each method is compared to clarify the composite's failure behavior. An explicit Finite Element Analysis (FEA) of impact scenarios has been performed to understand the deformation behavior of polymer-reinforced composites and to determine the absorbed impact energy, thereby clarifying which specimen is better able to absorb bending impact energy. Primarily, three polymer-reinforced specimens were accepted with a hollow Al tube. After initial tests and simulations, the expected parametric study could not be achieved except for one. Then, three more combinations were offered. For one of the three specimens, the thickness of the central reinforcement PP was increased until a fully developed shaft was produced, resulting in better-than-expected bending impact-absorbing performance. The results indicate that the energy level of the inner reinforcements with polymeric materials increased 8.8 times, to about 750 J, compared to the plain Al tube (85 J) under bending impact loads. The numerical simulations are relevant and reliable for the details of the specimens' impact process and show good agreement with the experimental results. Finally, depending on the content, this research, rather than focusing on the fundamental concept of polymer-reinforced aluminum crash tubes, focuses on the specific dynamic bending impact evaluation of the Al, PA6, and PP configuration and the design insight that hollow PP reinforcement can accelerate fracture. In contrast, a fully filled PP core inside a PA6 sleeve can suppress splitting and substantially improve impact energy absorption.