Effect of the Annealing Treatment on the Microstructure and Properties of TC4 Titanium Alloy TIG and Laser-Welded Joints

This study compares the microstructural evolution and mechanical properties of TC4 (Ti-6Al-4V) titanium alloy joints welded by Tungsten Inert Gas (TIG) and laser processes, following a post-weld annealing treatment at 650 °C for 2 h. Distinct microstructures were obtained: the TIG-welded joint developed a heterogeneous mixture of short-rod α and lamellar β, while the laser-welded joint formed a more homogeneous equiaxed α structure with uniformly distributed β-phase nanoparticles. Electron backscatter diffraction (EBSD) results confirmed that the annealing treatment significantly weakened the strong welding-induced texture and disrupted the epitaxial growth mode of columnar grains. Mechanical testing demonstrated that annealing improved the strength-toughness balance, but the extent and mechanism differed between the two processes. For the TIG-welded joint, the ultimate tensile strength slightly decreased, while elongation and impact toughness increased by 18% and 10.4%, respectively. In contrast, the laser-welded joint maintained its original strength while achieving greater improvements in ductility and toughness, with elongation and impact toughness increasing by 20% and 15.2%, respectively. This divergence is attributed to insufficient recrystallization and the persistence of residual coarse grains, limiting the TIG joint’s performance. However, in the laser-welded joint, the pinning effect of β-phase nanoparticles and associated grain refinement enhanced ductility without compromising strength.