Design and Verification of 6-DOF Robotic Arm for Captive Trajectory System Applications in Wind Tunnel

Accurate prediction of store trajectories at the point of release from an unmanned/manned aircraft is an essential requirement for safety and precision. Captive Trajectory System (CTS) is a well-known feature of wind-tunnel testing to simulate the dynamics of store separation. To accurately replicate real-world aerodynamic conditions based on measured forces and moments, it utilizes a six-degree-of-freedom (6-DOF) robotic arm controlled by a closed-loop control system that solves the store’s equations of motion. In this study, a wing–pylon–store configuration is used as a sample case, and published experimental trajectories are used as input. A 6-DOF robotic arm named ROBO-S is designed to follow these trajectories in a CTS setup. The kinematic analysis of ROBO-S is performed in this study. The Denavit–Hartenberg (DH) method is used for the calculation of forward kinematics, whereas geometric techniques are used for inverse kinematics calculations. A simulation of kinematic analysis is performed in MATLAB R2021a. The mechanical design of ROBO-S is carried out in PTC CREO 9.0. MATLAB simulations confirm that the robotic arm can follow the trajectory obtained from published experimental results. To demonstrate the feasibility of the design, the robotic arm is fabricated using 3D printing. The results demonstrate the potential of the developed system in accurately following trajectories for wind-tunnel testing applications.