Design and Performance Study of Stiffness-Reduced Rubber Isolation Bearings

To address the poor vertical vibration reduction in laminated rubber bearings, the high cost and low practicality of combined three-dimensional isolation bearings, and the low load-bearing capacity of thick-layer rubber bearings, this paper proposes a stiffness-reduced rubber isolation bearing. Based on the deformation coordination principle and the incompressibility of thick-layer rubber, theoretical formulas for the horizontal and vertical stiffness of the proposed bearing are established. Compression–shear tests and finite element simulations are then conducted to investigate its mechanical properties under vertical compressive stress. The results show that the theoretical predictions agree well with the simulation and experimental results. The maximum error of horizontal stiffness is no more than 5.6% relative to the finite element simulation and no more than 3.3% relative to the experimental results, while the maximum error of vertical stiffness is no more than 7.9% and 2.3%, respectively. Compared with the traditional laminated rubber bearing, the stiffness-reduced rubber isolation bearing reduces the average vertical stiffness by 35.8% while maintaining stable horizontal mechanical performance and overall integrity within the tested range. Furthermore, parametric analysis indicates that the stiffness can be effectively adjusted by changing the inner-diameter/outer-diameter ratio. A case study based on measured metro-induced vibration time-history curves further shows that the proposed bearing has potential for achieving the dual objective of horizontal isolation and vertical vibration reduction.