Effects of moisture content on temperature stability and microbial population growth over time in a dry cow total-mixed ration

Controlling energy with high-fiber diets throughout the entire dry period is a nutritional strategy aimed at preventing overconsumption of nutrients, but this may result in lower moisture content.Conversely, total mixed rations (TMR) with high moisture content are more prone to spoilage, especially under elevated environmental temperatures.High temperatures signal spoilage caused by microorganisms present in the TMR, which generate heat and diminish the ration's nutrient value.Therefore, the objective of this study was to evaluate the effects of the addition of water to a dry cow TMR containing wheat straw (37% of total dietary DM) on TMR temperature and microbial populations.Three separate runs were conducted, each with 6 3.78-L buckets randomly allocated to 2 treatment groups (n = 3 per treatment): NW (with no water added; 49% DM) and WW (with 7.3 kg of water added to the mixture; 43% DM).Temperature recording began immediately after filling the buckets with their corresponding treatments using data loggers (n = 3 per bucket; Thermochron iButtons, iButtonLink, Whitewater, WI), placed at the bottom, middle and top of each bucket.The average temperature for all locations was used.Data loggers were set to record at 5-min intervals and summarized as hourly averages for 24 h.In addition, data loggers (n = 3) were placed outside of the buckets to register ambient temperature.Samples of TMR were collected at 0, 6, 12, 18 and 24 h after the mixture was prepared and placed into buckets.Three samples per treatment were composited at each time point and the composites were plated for yeast, total bacteria, and clostridial counts.Data were analyzed using the MIXED procedure in SAS.There was no treatment effect for TMR temperature (NW = 29.1 0.76C and WW = 30.6 0.76C).A main effect of time point (h) was observed for TMR temperature, total bacteria, and yeast.The TMR temperature tended to be higher for WW (34 1.56, 35 1.59, 35 1.57, 35 1.49C) than NW (29 1.56, 29 1.59, 30 1.57, 30 1.49C) at 16, 17, 18, and 19 h, respectively.In contrast, NW had increased yeast counts compared with WW.Overall, water addition to a dry cow TMR appeared to impact feed temperature after 16 h of its preparation and reduced yeast growth over time but did not impact total bacterial or clostridial counts.

Authors

Institutions

Publication Details

Journal
JDS Communications
Published
2026-03-01
DOI
https://doi.org/10.3168/jdsc.2025-0978
Primary Topic
Effects of Environmental Stressors on Livestock
Type
article
Field-Weighted Citation Impact
0.00
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
article

Effects of moisture content on temperature stability and microbial population growth over time in a dry cow total-mixed ration

F.F. Cardoso, F C Cardoso, L. Garcia
JDS Communications
Effects of Environmental Stressors on Livestock
article

Effects of moisture content on temperature stability and microbial population growth over time in a dry cow total-mixed ration

F.F. Cardoso, F C Cardoso, L. Garcia
article en

Abstract

Controlling energy with high-fiber diets throughout the entire dry period is a nutritional strategy aimed at preventing overconsumption of nutrients, but this may result in lower moisture content.Conversely, total mixed rations (TMR) with high moisture content are more prone to spoilage, especially under elevated environmental temperatures.High temperatures signal spoilage caused by microorganisms present in the TMR, which generate heat and diminish the ration's nutrient value.Therefore, the objective of this study was to evaluate the effects of the addition of water to a dry cow TMR containing wheat straw (37% of total dietary DM) on TMR temperature and microbial populations.Three separate runs were conducted, each with 6 3.78-L buckets randomly allocated to 2 treatment groups (n = 3 per treatment): NW (with no water added; 49% DM) and WW (with 7.3 kg of water added to the mixture; 43% DM).Temperature recording began immediately after filling the buckets with their corresponding treatments using data loggers (n = 3 per bucket; Thermochron iButtons, iButtonLink, Whitewater, WI), placed at the bottom, middle and top of each bucket.The average temperature for all locations was used.Data loggers were set to record at 5-min intervals and summarized as hourly averages for 24 h.In addition, data loggers (n = 3) were placed outside of the buckets to register ambient temperature.Samples of TMR were collected at 0, 6, 12, 18 and 24 h after the mixture was prepared and placed into buckets.Three samples per treatment were composited at each time point and the composites were plated for yeast, total bacteria, and clostridial counts.Data were analyzed using the MIXED procedure in SAS.There was no treatment effect for TMR temperature (NW = 29.1 0.76C and WW = 30.6 0.76C).A main effect of time point (h) was observed for TMR temperature, total bacteria, and yeast.The TMR temperature tended to be higher for WW (34 1.56, 35 1.59, 35 1.57, 35 1.49C) than NW (29 1.56, 29 1.59, 30 1.57, 30 1.49C) at 16, 17, 18, and 19 h, respectively.In contrast, NW had increased yeast counts compared with WW.Overall, water addition to a dry cow TMR appeared to impact feed temperature after 16 h of its preparation and reduced yeast growth over time but did not impact total bacterial or clostridial counts.

JDS Communications
University of Illinois Urbana-Champaign (US), Urbana University (US), University of Maryland, College Park (US)
Zero hunger
Openalex Percentile: Top 6%
Effects of Environmental Stressors on Livestock
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.