Combustion Characterization and Heat Loss Determination Through Experimental Investigation of Hydrogen Internal Combustion Engine

Hydrogen combustion is known to be fast compared to traditional hydrocarbon fuels. The fast combustion leads to a higher thermal efficiency. In this research a 600 cc single cylinder hydrogen engine was tested at 1250 rpm, lambda = 2 and 3, and three load levels (load was represented by Manifold Absolute Pressure (MAP); MAPs tested were 75, 95 and 120 kPa) and compared to operation with gasoline and propane. The fast burn duration (Mass Fraction Burnt MFB10% to MFB90%) and the MFB 50% were determined and analyzed. The hydrogen MFB50% location for Minimum Timing for Best Torque (MBT) was found to occur at around the typical 8 Crank Angle Degrees (CADs) After Top Dead Center (ATDC). Measurements of ignition delay based on the fast data direct measurement of spark ignition coil current drop to the change in polarity of net heat release are presented. With shifts towards direct injection and higher injection pressures, consideration was given to the hydrogen pressurization penalty, where it was calculated that pressurizing hydrogen to 100 bar at the flow required for lambda = 2 operation is 2.3 bar, i.e., higher than the Friction Mean Effective Pressure (FMEP)! Furthermore, hydrogen is widely cited to have a higher heat loss than typical hydrocarbon fuels. In this paper, detailed analyses at lambda 2 and lambda 3 showed that hydrogen in fact has lower heat losses.