Experimental Research into the Thermal Properties of Structural Barriers Produced Using Additive Methods and Phase Change Materials (PCMs)

Construction technologies and materials engineering are collaborating to develop new solutions that enhance energy efficiency. One such solution is thermal barriers filled with phase change material. Thanks to their thermal properties, these innovative barriers are being used in an increasing number of construction projects. Additive manufacturing enables the production of architected thermal barriers with controlled cellular topologies and customized heat transfer pathways. This study investigates the thermal performance of lightweight partitions produced using masked stereolithography (m-SLA) 3D printing, focusing on two geometries: open-cell Kelvin structures and closed-cell honeycomb structures. Two strategies for incorporating phase change material were evaluated: direct addition of 10% and 30% paraffin oil by weight to the photopolymer resin and post-print filling of cellular voids with a PCM-based gel. The aim was to establish the effect of topology and PCM distribution on steady-state thermal parameters and transient temperature stabilization. Experimental testing under cyclic heating–cooling conditions revealed that increasing paraffin oil content significantly improves thermal performance. The open-cell Kelvin structure with 30% PCM exhibited the lowest thermal conductivity (λ = 0.0289 W/(m·K)) and the highest thermal resistance (R = 0.697 m2·K/W). Honeycomb structures achieved λ = 0.0360 W/(m·K) and R = 0.590 m2·K/W at the same PCM content. Transient analysis demonstrated enhanced temperature stabilization, with maximum ΔT values of 29.55 K (30% PCM) and 28.61 K (honeycomb 30%). These results confirm that the geometry produced by additive manufacturing plays a decisive role in governing heat transfer and latent heat utilization in PCM-based thermal barriers.