Optimization of the Operating Behavior of Spur Gears Through Machine Hammer Peening

Gear systems operate under high mechanical and tribological loads, making their surfaces vulnerable to wear and fatigue. Improving surface durability requires finishing processes that improve near-surface properties and extend service life. Since machine hammer peening (MHP) offers such potential, this study investigates its influence on the performance of case-hardened spur gears and evaluates its suitability as an alternative to shot peening as a conventional finishing method. Analog specimens with simplified geometries were treated using various MHP parameters to identify effective process settings. These optimized settings were then applied to real spur gears to assess performance under practical conditions. The experiments showed that MHP can significantly modify surface integrity, achieving surface roughness reductions of up to 55%, surface hardness increases of up to 30%, and compressive residual stresses exceeding −1400 MPa with stability to depths of 200 µm. These modifications resulted in improved wear and fatigue performance, with increases in load cycle number in the tooth flank up to 99% and an increase in load amplitude in the tooth root of more than 5%. For comparison, specimens were also treated with shot peening. Although MHP induced stronger surface integrity modifications, shot peening achieved higher overall load-carrying capacity because several critical areas could not be fully accessed by MHP, limiting its effectiveness. Overall, MHP shows promise as a finishing process, but its full potential depends on overcoming accessibility limitations in complex gear geometries.