Assessment of Creep Reduction Factors of High-Density Polyethylene Geogrids Using Conventional and Stepped Isothermal Methods

The long-term creep performance of geosynthetics is crucial for the safe design of reinforced-soil structures. Previous studies have not sufficiently clarified the long-term creep behavior of high-density polyethylene (HDPE) geogrids or the influence of different failure criteria. Therefore, further research is needed to validate creep reduction factors' (RF_CR) estimation and the applicability of the stepped isothermal method (SIM). In this study, the creep behavior of HDPE geogrids was examined using both conventional creep tests and SIM, conducted in accordance with ISO 13431 and ASTM D6992. Master curves were generated under load levels representing 40-60% of the ultimate tensile strength. The SIM results matched with the conventional tests in the early stage but exhibited higher creep strains beyond 1000 h, primarily due to the thermal sensitivity of HDPE. RF_CR values were determined using two design criteria, namely, 20% creep strain and creep rupture. For a 100-year design life, the RF_CR values based on a 20% creep strain were determined to be 3.04 and 2.43 based on the combined data and block-shift analysis, respectively, whereas the rupture criterion yielded a lower value of 2.30. These findings demonstrate that the 20% strain limit provides a more conservative and reliable criterion for estimating the long-term design strength. This study confirms the applicability of SIM for accelerated creep evaluation and provides practical guidance for the selection of RF_CR values in reinforced-soil design.