Investigation of Geometrical and Numerical Parameters on Ultra-High-Performance Concrete Link Slab Performance Using Finite Element Modeling

Traditional expansion joints in bridge structures are prone to durability problems, such as leakage, corrosion, and high maintenance demands, which can significantly reduce service life. To overcome these limitations, ultra-high-performance concrete (UHPC) link slabs have emerged as an effective jointless solution; however, their mechanical performance and sensitivity to key design and modeling parameters are not yet fully understood. This study presents a nonlinear finite element investigation of UHPC link slabs using the Concrete Damaged Plasticity (CDP) model in ABAQUS. A baseline model, validated against the experimental results, was established with a link slab length of 1100 mm and representative material and detailing properties. A systematic sensitivity analysis was then performed by varying five geometrical parameters (link slab length and thickness, debonding length, reinforcement diameter, and reinforcement spacing) and five numerical/material parameters (non-debonding and debonding interface friction coefficient, UHPC and normal concrete compressive strength, and steel yield strength). For each case, the load–displacement response was examined through initial stiffness (K0), yield and peak load–deformation values (Py, Δy and Pu, Δu), and ductility ratio (μ). The results highlight the dominant role of reinforcement detailing; larger bar diameters and closer spacing substantially increased stiffness and strength while maintaining ductility. Debonding length emerged as a critical tuning parameter, with longer debonding improving ductility but slightly reducing strength. Slab thickness primarily influenced stiffness, whereas overall length showed minor effects on peak capacity. On the numerical side, steel yield strength proved to be the most influential input, affecting all response measures, while the non-debonding interface friction coefficient strongly governed yield capacity. Variations in the debonding friction coefficient, UHPC compressive strength, and normal concrete strength exhibited secondary influence within the tested ranges. Overall, the findings provide practical guidance for both the designing and detailing of UHPC link slabs and the calibration of FEM (finite element modeling) models. By clarifying which parameters most strongly govern stiffness, strength, and ductility, this study supports more reliable structural design and efficient numerical modeling of UHPC link slabs in accelerated bridge construction applications.