From biomass residues to syngas: Intensified biogas upgrading through nickel hydroxyapatite-catalysed dry reforming

Industrial lignocellulosic biomass (LB) residue obtained after steam explosion (SE) pretreatment was subjected to anaerobic digestion (AD) under mesophilic conditions (37 ± 1 °C) at a substrate-to-inoculum ratio of 1:2 using a pressure-transducer-based gas measurement system. Over a 36-day batch digestion period, specific biogas and methane yields of 97.69- and 67.27-mL g −1 VS fed at STP, respectively, were obtained under the constraints of pressure-based gas quantification. The produced biogas was converted into syngas rich in hydrogen (H 2 ) and carbon monoxide (CO), via dry reforming (DRM) using eggshell-derived nickel-based hydroxyapatite (Ni-HAP E ) and nickel-based catalyst supported on a commercial Hydroxyapatite (Ni-HAP C ). Characterisation of LB residue revealed an unexpectedly high apparent lignin content which was attributed to pseudolignin. Pressure fluctuations associated with invasive gas sampling were also recorded on the AD system, suggesting that measurement artefacts primarily contributed to low recorded gas production, with pseudolignin acting as a contributing factor. The importance of non-invasive gas sampling when using pressure-based AD systems is highlighted. DRM tests at 800 °C and atmospheric pressure with Ni-HAP E and Ni-HAP C showed consistently high CH 4 conversion (>90 %), while CO 2 conversion varied strongly with feed composition, ranging from 60 % at CO 2 /CH 4 = 3.47 to > 90 % at ratios of 1.0 and 0.82. H 2 and CO selectivities peaked near the stoichiometric ratio (CO 2 /CH 4 = 1.0), both exceeding 90 %, but declined sharply under CO 2 -rich (H 2 = 70 %, CO = 50 %) or CH 4 -rich (H 2 = 75 %, CO = 65 %) conditions. These findings provide practical guidance for improving AD, DRM and advancing bioenergy pathways. • Integrated AD of industrial lignocellulosic residue with DRM of AD-derived biogas. • Methane potential assessed using a pressure-transducer-based BMP system. • Residue characterization revealed features consistent with pseudolignin formation. • Valorization of eggshell waste produced stable hydroxyapatite catalyst support. • Ni/HAP catalyst achieved >90 % CH 4 conversion and high H 2 /CO selectivity in DRM.

Authors

Institutions

Publication Details

Journal
Biomass and Bioenergy
Published
2026-02-03
DOI
https://doi.org/10.1016/j.biombioe.2026.108989
Citations
1
Primary Topic
Anaerobic Digestion and Biogas Production
Type
article
Field-Weighted Citation Impact
25.98
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
article

From biomass residues to syngas: Intensified biogas upgrading through nickel hydroxyapatite-catalysed dry reforming

Vaibhavi Bele, Inès Esma Achouri, Hanaa Hassini, Adrien Rizzi
1 citations
Biomass and Bioenergy
Anaerobic Digestion and Biogas Production
25.98
article

From biomass residues to syngas: Intensified biogas upgrading through nickel hydroxyapatite-catalysed dry reforming

Vaibhavi Bele, Inès Esma Achouri, Hanaa Hassini, Adrien Rizzi
article en
1 citations

Abstract

Industrial lignocellulosic biomass (LB) residue obtained after steam explosion (SE) pretreatment was subjected to anaerobic digestion (AD) under mesophilic conditions (37 ± 1 °C) at a substrate-to-inoculum ratio of 1:2 using a pressure-transducer-based gas measurement system. Over a 36-day batch digestion period, specific biogas and methane yields of 97.69- and 67.27-mL g −1 VS fed at STP, respectively, were obtained under the constraints of pressure-based gas quantification. The produced biogas was converted into syngas rich in hydrogen (H 2 ) and carbon monoxide (CO), via dry reforming (DRM) using eggshell-derived nickel-based hydroxyapatite (Ni-HAP E ) and nickel-based catalyst supported on a commercial Hydroxyapatite (Ni-HAP C ). Characterisation of LB residue revealed an unexpectedly high apparent lignin content which was attributed to pseudolignin. Pressure fluctuations associated with invasive gas sampling were also recorded on the AD system, suggesting that measurement artefacts primarily contributed to low recorded gas production, with pseudolignin acting as a contributing factor. The importance of non-invasive gas sampling when using pressure-based AD systems is highlighted. DRM tests at 800 °C and atmospheric pressure with Ni-HAP E and Ni-HAP C showed consistently high CH 4 conversion (>90 %), while CO 2 conversion varied strongly with feed composition, ranging from 60 % at CO 2 /CH 4 = 3.47 to > 90 % at ratios of 1.0 and 0.82. H 2 and CO selectivities peaked near the stoichiometric ratio (CO 2 /CH 4 = 1.0), both exceeding 90 %, but declined sharply under CO 2 -rich (H 2 = 70 %, CO = 50 %) or CH 4 -rich (H 2 = 75 %, CO = 65 %) conditions. These findings provide practical guidance for improving AD, DRM and advancing bioenergy pathways. • Integrated AD of industrial lignocellulosic residue with DRM of AD-derived biogas. • Methane potential assessed using a pressure-transducer-based BMP system. • Residue characterization revealed features consistent with pseudolignin formation. • Valorization of eggshell waste produced stable hydroxyapatite catalyst support. • Ni/HAP catalyst achieved >90 % CH 4 conversion and high H 2 /CO selectivity in DRM.

Biomass and BioenergyVol. 210
Université de Sherbrooke (CA), CRB Innovations (Canada) (CA)
Openalex Percentile: Top 1%
Anaerobic Digestion and Biogas Production
25.98
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.