Dynamic Cone Penetration Test in Lunar Highlands Regolith Simulant

It is essential to understand the geotechnical properties of the ground before anything can be built on Earth, the Moon, or elsewhere. The cone penetrometer is a simple but very important instrument that yields quantitative and qualitative information about the geotechnical properties of the material. Quantitative information is the penetration resistance from which density and layering can be inferred, and ground improvement can be evaluated. Qualitative information includes identifying layering and inhomogeneities, as well as the existence of boulders. Cone penetrometers are often proposed for space missions (e.g., Beagle 2, InSight, Philae) and were even used by Apollo astronauts. All cone penetrometers that have been used extra-terrestrially so far have either experienced difficulties with penetration or were designed to penetrate less than 100 mm deep and stop before encountering any meaningful resistance. An optimally developed dynamic cone penetrometer might work better because it requires less reaction force. This research consists of the development of a bespoke dynamic cone penetrometer with variable cone size and hammering energy. Further, this instrument is tested in a large-scale regolith compaction chamber with lunar highlands regolith simulant LHS-1E at a wide range of densities to find the optimal setup where penetration captures enough data by moving slowly but also does not stagnate. Results from dynamic cone penetration tests at many different densities are compared and successfully correlated to cone penetration and nuclear density gauge test results. Calculated coefficients allow for the conversion directly between dynamic and regular cone penetration tests at any density, which shows promise for greater use of dynamic cone penetrometers in lunar applications. • Large-scale dynamic cone penetration test in lunar regolith simulant. • Correlation between cone penetration test and dynamic cone penetration tests. • Correlation between cone penetration resistance and regolith simulant density. • Dynamic cone penetration test could be used on the Moon. • Large-scale lunar regolith simulant preparation in controlled density.