Roller Joining of AA1050 and AA6061 Aluminum Foam Immediately After Heating Process

Aluminum foam is attracting attention as a multifunctional, ultra-lightweight material. To apply this aluminum foam to actual industrial materials, aluminum foam plates are required. In addition, it is expected that a multi-layer aluminum foam composed of dissimilar aluminum alloy foam layers can further enhance its functionality. In this study, we attempted to fabricate a three-layer aluminum foam composed of commercially pure aluminum AA1050 and Al-Mg-Si aluminum alloy AA6061 by heating and foaming a total of three pieces of AA1050 precursor and AA6061 precursor arranged alternately, followed by immediate roller joining. It was found that, by traversing a roller immediately after foaming the AA1050 and AA6061 precursors, the aluminum foam could be joined while forming it into a flat plate. In addition, X-ray CT images of the fabricated samples revealed that material flow induced by roller traversing ruptured the surface skin layer. Numerous pores were observed within the sample, indicating pores were maintained during the roller traversing and no significant differences in porosities were identified between AA1050 aluminum foam and AA6061 aluminum foam. Furthermore, from the four-point bending test and the observation of samples after bending test, although quantitative mechanical properties were not obtained due to the as-joined samples were used for the bending test, pores were observed at the fracture surfaces, confirming that roller joining achieved seamless joining.