Investigation on the Fresh and Mechanical Properties of Low Carbon 3D Printed Concrete Incorporating Sugarcane Bagasse Ash and Microfibers

The use of recycled materials and locally sourced alternative binders in 3D concrete printing (3DCP) has significant potential to reduce carbon emissions in concrete construction. This study examines the effect of sugarcane bagasse ash (SCBA), a byproducts from the sugarcane industry, as a sustainable binder in 3DCP. SCBA was oven-dried at 105 °C, sieved to 250 µm, and used to replace up to 25% of the total binder by weight in a supplementary cementitious material (SCM) blended system. The impact of polypropylene (PP) and steel (ST) microfibres on SCBA-based mixes was also investigated. The fresh properties of the mortar were evaluated using the flow table, Vicat needle, shape retention, buildability, and rheometer tests. The mortar was 3D printed using a small-scale robotic setup with a RAM extruder. Mechanical properties were then tested, including compressive and flexural strengths, and interlayer bonding, along with microstructure analysis. The results showed that increasing the SCBA content led to greater slump and improved flowability, as well as a slower rate of static yield stress development, with up to a 90 percent reduction compared to the control mix. The addition of PP fibres doubled the static yield stress in the mixes containing 20 percent SCBA. The 10 percent SCBA mix achieved the highest mechanical strength, both in compression and flexure, due to its denser microstructure and enhanced pozzolanic reaction.