Addressing Challenges in Porous Silicon Fabrication for Manufacturing Multi-Layered Optical Filters

The motivation for this work is to study the cause and present mitigation for some challenges faced in preparing porous silicon. This enables benefiting from the appealing benefits of porous silicon that offers a wide range, simple technique for varying the refractive index. Such challenges include the refractive index values, sensitivity to oxidation, some fabrication parameters, and other factors. Additionally, highly doped p-type silicon is preferred to form porous silicon, but it causes high losses, which necessitates its detachment. We investigate some possible causes of refractive index change, especially after detaching the fabricated layers from the silicon substrate. Thereby, we could recommend simple but essential precautions during fabrication to avoid such a change. For example, the native oxide formed in the pores has a role in changing the porosity upon following some fabrication sequence. Oppositely, intrinsic stress doesn’t have a significant role. On another aspect, the effect of differing etching/break times on the filter’s responses has been studied, along with other subtle details that may affect the lateral and depth homogeneity, and thereby the process success. Solving such homogeneity issues allowed reaching thick layers not suffering from the gradient index. It is worth highlighting that several approaches have been reported; unlike these, our method doesn’t require sophisticated equipment that might not be available in every lab. To well characterize the thin films, it has been found essential that freestanding monolayers are used for this purpose. From which, the wavelength-dependent refractive index and absorption coefficient have been determined in the near infrared region (1000–2500 nm) for different fabricated conditions. Excellent fitting with the measured interference pattern has been achieved, indicating the accurate parameter extraction, even without any ellipsometry measurements. This also demonstrates the refractive index homogeneity of the fabricated layer, even with a large thickness of over 16 µm. Subsequently, multilayer structures have been fabricated and tested, showing the successful nano-manufacturing methodology.