Effects of Cross-Linked Structure of Sodium Alginate on Electroosmotic Dewatering and Reinforcement for Coastal Soft Soil

The reinforcement of high-water-content, low-permeability soft soils presents a critical challenge in marine and coastal engineering. While electroosmotic dewatering is a promising technique, its widespread application is often hindered by issues such as high energy consumption and limited strength gain. However, the specific mechanisms by which marine-derived biopolymers modify soil properties and microstructure to enhance electroosmotic efficiency and significantly improve the post-treatment bearing capacity remain insufficiently understood. To address this gap, this study investigates the use of Sodium Alginate (SA) to enhance the electroosmotic dewatering performance of coastal soft soil. Laboratory experiments were conducted using carbon felt electrodes with varying SA mass fractions (0.0%, 0.2%, 0.5%, and 1.0%). The study integrated macroscopic monitoring with Scanning Electron Microscopy (SEM) to evaluate the electroosmotic efficiency and mechanical property evolution. The results demonstrate that the cross-linked structure of SA gel effectively bridges soil particles and fills inter-granular pores, significantly increasing the liquid limit (from 32.34% to 49.15% at 1.0% SA) and mitigating soil cracking. This microstructural alteration enhanced electrical conductivity and accelerated drainage; the average water content reduction increased from 12.78% (0.0% SA) to 20.86% (1.0% SA). Notably, the 0.5% SA treatment improved the average bearing capacity to approximately 86 kPa (about 7 times that of 0.0% SA) with only a 21% increase in the energy consumption coefficient. This study confirms that utilizing SA for electroosmotic reinforcement effectively modifies soil properties to provide a marine solution for coastal soft soil foundation treatment.