The Influence of Leading Edge Tubercle on the Transient Pressure Fluctuations of a Hubless Propeller

In recent years, the design priorities of modern marine propellers have shifted from maximizing efficiency to minimizing vibration-induced noise emissions and improving structural durability. However, an optimized design does not necessarily ensure optimal performance across the full operational range of a vessel. Due to operational constraints such as reduced docking times and regional speed regulations, propellers frequently operate off-design. This deviation from the design point leads to periodic turbulent boundary layer separation on the propeller blades, resulting in increased unsteady pressure fluctuations and, consequently, elevated hydroacoustic noise emissions. To mitigate these effects, bio-inspired modifications have been investigated as a means of improving flow characteristics and reducing pressure fluctuations. Tubercles, characteristic protrusions along the leading edge of humpback whale fins, have been shown to enhance lift characteristics beyond the stall angle by modifying the flow separation pattern. However, their influence on transient pressure fluctuations and the associated hydroacoustic behavior of marine propellers remains insufficiently explored. In this study, we apply the concept of tubercles to the blades of a hubless propeller, also referred to as a rim-drive propeller. We analyze the pressure fluctuations on the blades and in the wake by comparing conventional propeller blades with those featuring tubercles. The flow fields of both reference and tubercle-modified blades were simulated using the Stress Blended Eddy Simulation (SBES) turbulence model to highlight differences in the flow field. In both configurations, multiple helix-shaped vortex systems form in the propeller wake, but their decay characteristics vary, with the vortex structures collapsing at different distances from the propeller center. Additionally, Proper Orthogonal Decomposition (POD) analysis was employed to isolate and analyze the periodic, coherent flow structures in each case. Previous studies on the flow field of hubless propellers have demonstrated a direct correlation between transient pressure fluctuations in the flow field and the resulting noise emissions. It was demonstrated that the tubercle modification significantly reduces pressure fluctuations both on the propeller blades and in the wake flow. In the analyzed case, a reduction in pressure fluctuations by a factor of three to ten for the different BPF orders was observed within the wake flow.