Experimental Investigation on Cutting Force and Hole Quality in Milling of Ti-6Al-4V

High-quality hole machining of Ti-6Al-4V is critical for precision aerospace components but remains challenging due to the alloy's poor machinability. In this study, the influence of cutting parameters on milling force, burr formation and the hole quality of Ti-6Al-4V was investigated. The mechanical properties and microstructure of the milled holes were analyzed. The research results show that milling depth is the primary factor governing variations in milling force and burr formation. The minimum milling force of 3.61 N is achieved at a milling depth of 60 μm, a feed per tooth of 2 μm/z and a cutting speed of 31 m/min. Compared to pre-optimization parameters, the milling force is decreased by 91.74%. Correspondingly, entrance burr width and hole-axis deviation were substantially reduced, indicating marked improvement in hole quality and geometrical accuracy. Microstructural observations show no deleterious phase transformations or excessive work-hardening under the optimized regime. The results deliver quantitative guidelines for parameter selection and tool application in micro-hole milling of Ti-6Al-4V and provide a foundation for further process modelling and optimization for aerospace manufacturing.