The Use of the Overmolding Technique for the Preparation of Basalt Fiber (BF)-Based Composite, the Comparative Study of Poly(ethylene terephthalate)/Polycarbonate—PET/PC and Poly(butylene terephthalate)—PBT/PC Blends

The presented study is focused on the evaluation of the mechanical and heat resistance performance of the polyester-based injection-molded components. For comparative purposes, we used a poly(ethylene terephthalate)/polycarbonate blend (PET/PC) and a poly(butylene terephthalate)/polycarbonate (PBT/PC) mixture, where both types of polymer blends were used as a matrix for different types of basalt fiber (BF)-reinforced composites. The investigated molding procedure consists of injection overmolding of the composite prepreg (insert). During the technological procedure, various material configurations were used, including overmolding with both unmodified blends and a composition with additional short basalt fibers. The results confirmed that the best balance of properties was obtained for complex parts reinforced with short BF and overmolded insert, where the tensile modulus can reach 8 GPa, while the impact strength was more than 30 kJ/m². The results of comparative tests indicate a significantly higher strength of overmolding joints for PET/PC-based materials. The relatively low heat deflection temp. (HDT) of around 70 °C after the injection molding procedure can be successfully improved by the annealing treatment, where the HDT can reach around 120 °C. The structural tests revealed that, besides some differences in crystallinity between the PET- and PBT-based blends, the thermomechanical performance of the manufactured composites is almost similar. It is worth pointing out the fundamental differences in the miscibility of the investigated blend systems, where for the PBT/PC mixture structural tests confirm the miscibility of polymer phases, while PET/PC particles are immiscible.